NZ series
5Pages

011.9mm bush ultra compact switch joysticks □ Compact Size □ Polyimide Flexi Tail Option □ 11.9mm Bush Mount □ Silicone Rubber Sealing Boots □ Alternate Handle Selection □ V5 switches up to 2 Amps

011.9mm bush ultra compact switch joysticks OPTION SELECTION LEVER / BOOT A Half Boot + Lever B Full Boot + Lever Polyimide tails only available with switch option A. Switch option A has pin terminals. Switch option B has solder terminals. Mechanical Life Lever Travel Lever Material Body Material Boot Material Mounting - Bush Recommended Panel Thickness (for half boot) Recommended Panel Thickness (for full boot) Impact Test Rating 1 Million Operations (maximum) Stainless Steel 35 to 45 grams (subject to configuration type) Silicone rubber Single Point 11.9mm Diameter IK09 (Lever / Boot...

011.9mm Bush ultra compact switch joysticks MOUNTING DETAILS_ Joystick Mounting (All versions) Note: Both full and half boots to be tightened to 1.5Nm to ensure the optional panel gasket is fully compressed. If extra security is required, use an appropriate bond to secure the nut to the bush. Take care when fitting boots over levers, ensuring they are not twisted, once installed. *Note: The grey port to the right represents the customer panel* * PI ease note images shown are for illustration purposes. NZwith Half Boot *Note: The grey part to the right represents the customer panel* Note:...

011.9mm Bush ultra compact switch joysticks (Resistive load) Tail and connector suitable for North Normally Open West Normally Open South Normally Open East Normally Open Switch Common NORMALLY OPEN NORMALLY CLOSED Tail and connector suitable for Small Control Signals only 1 North Normally Closed 2 East Normally Closed 3 East Normally Open 5 West Normally Closed 6 South Normally Closed Viewed from above 7 North Normally Open 8 West Normally Open 9 South Normally Open Note: The company reserves the right to change apeclflcatioru without notice.

011.9mm Bush ultra compact switch Joysticks CONFIGURATION OPTIONS The NZ Series is supplied with two switch options. Both options have a gold plated silver alloy contact, providing reliable switching at low current levels. Switch option A being suitable for up to 2A operation and option B being suitable for 10Oma operation. The anticipated life of the switches is heavily determined by the application and parameters such as load type. Please contact the factory for further advice about the expected switch performance under differing loads or DC power supplies. _MECHANICAL OPERATION_ All NZ...