Catalogs >
Cervis >
JS-100 Heavy Duty Proportional Joystick

JS-100 Heavy Duty Proportional Joystick
2Pages

Catalog excerpts

JS-100 Heavy Duty Proportional Joystick - 1

Engineering SpecSheet JS-100 Heavy Duty Proportional Joystick Features  Extreme Duty Design  Redundant Hall Effect sensors for each axis  Duty cycle 2+ million actuations  CANopen and J1939 CANbus configurations  Dual and single axis versions  Dual Axis +/–30° deflection  Integrated above panel LED diagnostics  IP67 above panel; IP65 below panel  Can be configured and monitored using JS-100 PC Interface  CAN participation can be passive (answers only to poll) or active (messages repeated on schedule) to assist in CAN traffic management  Linear and all non-linear output curves dynamically selectable via CAN commands. Custom output curves can be easily accommodated  Integrated TRUE ZERO Enable – joystick can be configured to require activation of the enable switch while in the zero position before any outputs can occur  X Axis and Y Axis signals for steering applications can be coordinated to reach simultaneous maximum values at the 45° position of each quadrant The JS-100 is a heavy duty industrial joystick designed for demanding applications. Engineered with robust overtravel end stops to withstand operator overstress, the unit provides reliable operation while in service. The 2mm thick joystick boot is field replaceable without removing the unit from the panel if damaged in service. There is a secondary seal below the boot that isolates the electronics to protect against cases where the boot may be compromised. Intrinsically safe versions are available for use in hazardous environments. Specifications Power Environment Operating Temp -40 to +60°C (-40° to +140°F) Boot material dependent Storage Temp IP67 above panel/IP65 below panel O-ring seal at panel Diagnostic Indicators (LEDs) Diagnostic LEDs can be controlled by the master controller for application specific projects. Error Watchdog/CAN Activity Redundant Hall Effect Each axis monitored and compared for consistent tracking with error-state sensing for out of tolerance. Integrated Hall Effect Enable Outputs CANbus J1939 or CANopen 16 addressable nodes via internal dip switch or via hardwired links in connecting cable back-shell Analog 0-5VDC for each axis 5mA sourcing or sinking, fault monitored Discrete Four (4) directional 5VDC for each axis 5mA sourcing, 100µA sinking External PWM Diagnostic/Configuration Windows compatible software available. Handle Configurations Valve driver modules available. Dimensions Inch JS-100 Heavy Duty Proportional Joystick ©20

Open the catalog to page 1

JS-100 Heavy Duty Proportional Joystick - 2

Engineering SpecSheet Heavy Duty Design with Unparalleled Sealing Rubber Push Pin Seal Secondary Seal Three O-Ring Profiles Molded in Custom Boot Extreme Duty Field Replaceable Flexible Boot Retaining Rings Captivate O-Ring Seal Lower Skirt of Boot Epoxy Sealed Cable Entry JS-100 PC Interface The JS-100 can be configured using its CAN port and a Windows based program. The program also allows for the device to be calibrated using the graphical user interface. In Monitor Mode, the program can provide information to allow the joystick functions to be monitored in real time. Ck ERVIS JS-100...

Open the catalog to page 2

JS-100 Heavy Duty Proportional Joystick 2Pages

Catalog excerpts

All Cervis catalogs and technical brochures

JS-100 Heavy Duty Proportional Joystick
2Pages