HPC Shark Line Catalogue (Updated 2019)
20Pages

New HPC line Z=4 Innovative High Performance end mills Stainless Steel Titanium and High temperature alloys

Reduced down time for tool change. Finishing at roughing feed now is possible. Machining cost reduction thanks to the new Cerin HPC end mills, designed and developed to maximize MRR in low and high alloy steels, stainless steels, Titanium and Nickel alloys. Benefits of the new Shark Line Maximum Material Removal Rate Vibrations free Roughing and finishing with the same tool Excellent chips evacuation

4 flutes with rounded cutting edges 4 flutes with sharp cutting edges Ball nose 4 flutes Ball nose 2 flutes 4 flutes with corner radius 4 flutes with corner radius and rounded cutting edges 4 flutes with point corner and sharp cutting edges 4 flutes point corner with rounded cutting edges 4 flutes without internal cooling 4 flutes with internal cooling Working Parameters

TOP Performance Uneven helix New generation multilayer coatings The geometries, the base material, the coatings are specifically developed for three large families of metallic materials.

Cutting edge preparation The purpose of honing , also called “cutting edges’ softening”, is the cutting edges’ strengthening reducing damages from impacts (especially in case of intermittent cutting such as milling). Honing does not affect cut, as the chip is pressed against the tool chest at a certain distance from the cutting edge. Cutting edge preparation: Greater cutting edge stability Increased mechanical and thermal cutting edge stability Higher output thanks to the increased cutting speed

Available with weldon flat only according to DIN 6535HA. Available with weldon flat only according to DIN 6535HA.

Available with weldon flat only according to DIN 6535HA. Available with weldon flat only according to DIN 6535HA.

Available with weldon flat only according to DIN 6535HA.

Available with weldon flat only according to DIN 6535HA.

Available with weldon flat only according to DIN 6535HA.

Available with weldon flat only according to DIN 6535HA.

Available with weldon flat only according to DIN 6535HA. Available with weldon flat only according to DIN 6535HA.

Available with weldon flat only according to DIN 6535HA.