*mydirectindustry

Catalogs
CERAMTEC
Soldering Conditions for Actuators

Soldering Conditions for Actuators

1 / 2 PagesView full catalog

Soldering Conditions for Actuators

Product catalog summary

Soldering Instructions for Actuators

Specifications:

Use a temperature-controlled soldering iron set to 320 °C with a tip width of less than 3 mm.
Utilize electronic grade solder wire with flux (L-Sn60PbAg4, F-SW26, or equivalent) or lead-free solder wire (S-Sn95Ag4Cu1). Avoid solder wires with aggressive flux.

Procedures:

Place the actuator on a thermally insulating surface such as ceramic, FR4, or thermal-resistant plastic.
First, create a small solder dot on the actuator, ensuring the soldering time is less than 10 seconds.
In a subsequent step, solder the pre-soldered leads to the solder dot.
If solder does not spread well, apply a small amount of flux (colophony resin in ethanol) to the solder pad before soldering. If issues persist, preheat the actuator to 60 °C using a heat plate or oven.
Avoid contact with the silicone-coated sides of the actuator using the soldering tip or bare hands; gloves should be worn.

Standards and Limitations:

The measured values are standard values determined for test samples based on DIN/DIN-VDE standards or CeramTec standards where applicable.
These values should not be applied to arbitrary formats or components with different surface qualities and do not guarantee specific properties.
Technical changes are reserved by CeramTec.

Recommendations:

Solder lead wires only to the designated soldering area, marked by a copper soldering pad inside the mesh electrode, indicated by a plus marker (black dot).

Catalog excerpts

Geschäftsbereich Multifunktionskeramik Multifunctional Ceramics Lötanweisung für Aktoren Soldering conditions for Actuators

Open the catalog to page 1

Die Anschlusslitzen dürfen nur im Lötbereich angelötet werden. Solder the lead wires only to the soldering area. Plus Markierung Plus marker (black dot) Plus Markierung Plus Markierung Lötbereich (Kupferfolie innerhalb Plus marker (black dot) innerhalb Lötbereich (Kupferfolie innerhalb Lötbereich (Kupferfolie Soldering area (copper soldering pad der Netzelektrode) der Netzelektrode) der Netzelektrode) inside the mesh electrode) Soldering area (copper soldering pad inside the mesh electrode) Soldering conditions: • emperaturgeregelte Lötstation, 320 °C an der Lötspitze, T • emperature controlled...

Open the catalog to page 2

All CERAMTEC catalogs and technical brochures

Archived catalogs

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list