CM-2-500
4Pages

CM-2-500 Permanent-magnet machine for direct drive of applications with highest speed demands. ▪ ▪ ▪ ▪ ▪ ▪ Special mechanical rotor construction for highest stresses Stator winding and core configuration for optimal efficiency despite highest rotational speeds Low heat generation in stator and rotor High-speed ball bearings with permanent lubrication Ideal in combination with converter CC-75-500 Customized adaptions available Specifications motor Pole-pair number Rated speed Rated power Rated torque Weight Temperature measurement Axial moment of inertia (rotor) Operating range Mechanical torque/phase current versus rotational speed an All rights reserved. All information in this document is based on Celeroton’s best knowledge and is not to be considered as a warranty or quality specification. The information given is designed as a guidance and customers are requested to check the suitability and usability of the product in their specific application with consulting Celeroton. The information herein is subject to change without notification.

Without boring/thread With M2 thread (right hand) Extended shaft stub (10.7 mm) Custom specific boring/thread Rotor type Rxxx Bearing type Bxx B00 (standard) B01 B99 Standard ball bearing Vacuum ball bearing Custom specific ball bearing Front flange Fxx F00 (standard) F01 F99 Standard flange, rotor dismountable only without front load attached Half-shell flanges, rotor dismountable with front load attached Custom specific front flange Cooling flange Cxx (air cooling) C00 (standard) C01 C02 C99 No cooling flange Cooling flange with radial inlet Cooling flange with axial inlet Custom specific...

Ordering information Article number All rights reserved. All information in this document is based on Celeroton’s best knowledge and is not to be considered as a warranty or quality specification. The information given is designed as a guidance and customers are requested to check the suitability and usability of the product in their specific application with consulting Celeroton. The information herein is subject to change without notification.

Cooling holes 8x Ø2 Mounting threads 4x M1.6 x 4.5 mm Depending on custom specific operation conditions and the corresponding Celeroton converter the operating range shown in this document may be different or may have additional limitations. For technical details and further information, please refer to the user manual or contact Celeroton directly. Celeroton AG | Industriestrasse 22 | 8604 Volketswil | Switzerland T: +41 44 250 52 20 | F: +41 44 250 52 29 | info@celeroton.com All rights reserved. All information in this document is based on Celeroton’s best knowledge and is not to be...