CC-100-1000
4Pages

CC-100-1000 Converter for driving permanent-magnet synchronous motors (PMSM) and brushless DC motors (BLDC). ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ Sensorless speed control from 5,000 rpm up to 500,000 rpm Maximum output power of 1,000 W No output filter required Separate supply for power and digital part User definable setup for different motor parameters Torque or speed control Integrated braking chopper up to 2 W Optional external braking chopper up to 420 W Highest possible efficiency Parallel connection of several converters to one DC-Bus possible User-friendly PC control software (CelerotonPilot) Specifications converter Input voltage power part Uin (DC) Input voltage digital part Uin (DC) Maximum output power (with respective cooling) Output voltage (peak value phase-phase) Maximum phase current (PAM-operation) Maximum frequency/speed (PAM-operation) Operating range Communication interface Communication interfaces (optional) PC control software Weight Dimensions (L x W x H) without heat sink Dimensions (L x W x H) with heat sink Operating temperature User interface (X7, X8) Connector X7 – I/O Interface (8 pins) 2 x Digital inputs 3 x Digital outputs 1 x COM 2 x GND 0–4V Low Level 10 – 24 V High Level 0 – 24 V (Relay, normally open contacts) Common rail for digital outputs Fundamental of the PAM block current All rights reserved. All information in this document is based on Celeroton’s best knowledge and is not to be considered as a warranty or quality specification. The information given is designed as a guidance and customers are requested to check the suitability and usability of the product in their specific application with consulting Celeroton. The information herein is subject to change without notification.

Connector X8 – I/O Interface (6 pins) 1 x Analog input 1 x Analog output 1 x Temperature measurement input 1 x Auxiliary power supply 2 x GND 0 – 10 V 0 – 10 V PTC or NTC, resistance range according to option Tx 10 V, 200 mA Operating range The operating range of the converter is dependent on the output voltage (Uout) (peak value phase-phase) in Figure 1. The output power (Pout) increases with the output voltage as the phase current (iph) (rms) is constant until the power limit is reached. Above that point iph decreases with increasing output voltage. The input voltage (Uin) (grey area)...

Order codes: CC-100-1000.SLx.Tx.HS Sensorless SLx Speed constants between 550 and 18,250 rpm/V Sensorless speed control from 7,000 rpm Speed constants between 400 and 7,900 rpm/V SL2 Sensorless speed control from 5,000 rpm The stated values are valid for number of pole pairs p=1. For higher number of pole pairs the speed constants and minimum speeds are divided by the number of pole pairs p. SL1 (Standard) Measurement range 6-150 Ω, e.g. PT100 Measurement range 0.26-86 kΩ, e.g. KTY84, NTC10k Heat sink HS _ (Standard) HS Without heat sink With heat sink Accessories Connector set CC-100-1000...

Celeroton AG | Industriestrasse 22 | 8604 Volketswil | Switzerland T: +41 44 250 52 20 | F: +41 44 250 52 29 | info@celeroton.com All rights reserved. All information in this document is based on Celeroton’s best knowledge and is not to be considered as a warranty or quality specification. The information given is designed as a guidance and customers are requested to check the suitability and usability of the product in their specific application with consulting Celeroton. The information herein is subject to change without notification.