Polypropylene honeycomb core PP8.80 / PP8-80T30 / PP8-80T30F75 Polypropylene honeycomb is mainly used as core in composite panels, as reinforcement and as means to lighten structures. Polypropylene honeycomb can be closed on both faces with a laminated skin. In case of bending the strain is transferred through the whole honeycomb core. For this reason, the strain is re-distributed between shear and compression over laminates. Polypropylene honeycomb can be thermo-welded or glued to a number of TNT or technical fabrics which make the production of composite panels easier. Polypropylene honeycomb is also used as support for lters and it is applied to diminish corrosive gas emissions. In fact, also the quality and the chemical-resistance of this product is also reliable in an aggressive environment. Honeycomb core’s properties Type Standard dimensions (other dimensions available on request) Effective temperature range °C * T30: - thermowelded foil 30gr/m3 for adhesion. ** T30F75: thermo-welded tissue for wet lay-up. 1 Density referred to the block dimension - Other dimensions, core heights and types upon request. - Minimum order quality for each type: 10 pallets. LIABILITY DISCLAIMER: The above data are to the best of our knowledge correct and are intended to give information about our products and their potential applications. No warranty is given or implied in respect of certain properties of the products or their suitability for a particular application. We reserve the right for technical changes without further notice. We guarantee impeccable product quality under our terms of sale. CEL Components S.r.l. Via Ca’ dell’Orbo Sud 4 - 40055 Castenaso (Bologna) Italy Tel. +39 051 782505 Fax +39 051 782477 www.cel.eu [email protected] P.IVA 04102600378 CCIAA BO 0339628 ALUMINIUM AND THERMOPLASTIC HONEYCOMBS, LAMINATES, SANDWICH PANELS