copyright © cedrat technologies i 02/2019 www.cedrat-technologies.com | [email protected] CEDRAT ( 7 TECHNOLOGIES X \ Innovation in Mechatronics TABLE OF STANDARD PROPERTIES OF USE AND MEASUREMENT The properties defined in the table below, are set up according to the technical conditions of use and measurement. These properties are warranted within their variation range and in compliance with the standard technical conditions of use. STANDARD TECHNICAL CONDITIONS VALUES VALUES VALUES > Notes Preliminary data CEDRAT TECHNOLOGIES • 59 Chemin du Vieux Chene • Inovallee • 38246 MEYLAN Cedex France • Tel. : +33 (0)4 56 58 04 00

copyright © cedrat technologies i 02/2019 www.cedrat-technologies.com | [email protected] CEDRAT ( 7 TECHNOLOGIES X \ Innovation in Mechatronics Any technical conditions of use, different from those defined above, can lead to temporary or definitive alterations of properties. Thank you to contact CEDRAT TECHNOLOGIES before using actuators under non standard technical conditions. FACTORY TESTS CARRIED OUT > Test 1 : Electrical admittance vs. Frequency, free-free > Test 2 : Displacement vs. input voltage OPTIONAL EXTRA FACTORY TESTS > Test 3 : Gain and linearity of the sensor > Test 4 : Step...

copyright © cedrat technologies i 02/2019 www.cedrat-technologies.com | [email protected] CEDRAT ( 7 TECHNOLOGIES X \ Innovation in Mechatronics DTT35XS 4 x M3,00 (Warning: Fixing screw lengths have to be less than 4mm) Note: Mirror0 up to 28mm Mechanical Interfaces: 4 x M3 on 0 30mm Warning: Screw lengths have to be < 4mm MECHANICAL INTERFACE CEDRAT TECHNOLOGIES • 59 Chemin du Vieux Chene • Inovallee • 38246 MEYLAN Cedex France • Tel. : +33 (0)4 56 58 04 00