CBG-Basalt-Fiber chops TDS-No. 1100 Chopped basalt fiber is a modern high-technology material which provides high strength, good mechanical properties, large thermal range of application. It is produced by cutting of continuous basalt roving into sections of required equal length. It is used as a reinforcing additive in various organic and inorganic matrices to increase the strength of the composite material. 100% natural origin ultrastrength material corrosion-resistant chemical resistance Properties Material Application area Monofilament diameter, μm Moisture content, % Application temperature, ºC Max. application temperature, ºC Loss weight at ignition, % Chops length, mm Storage Transportation ✓ high electrical resistance ✓ low thermal conductivity Data Basalt rock Reinforcement in construction industry, in architecture 9-17 <1 from - 250 up to + 1100 1300 from 0.2 up to 2.0 6, 12, 18, 24, 30, 36, 42, 48, 54, 60, 66, 72 In a dry place, in original packaging. Air humidity content should not exceed 80% Should be carried out by using covered vehicles to prevent absorption of moisture Processing and storage ✓ The usual protective measures must be taken during processing. Gloves, respiratory protection and safety glasses are recommended. Please note the instructions for use "Handling mineral wool and insulation materials (glass wool, rock wool)" from BG Bau. ✓ Storage in a dry place in original packaging, air humidity content should not exceed 80% CBG Composites GmbH Egerpohl 2 D-51688 Wipperfuerth / Germany The technical information on our products reflects the state of our knowledge at the time of printing. Therefore, the latest edition of the data sheet should always be used, as our experience and knowledge are constantly evolving. In case of doubt please contact us. The application shown is only exemplary and may vary in individual cases. It is therefore not relevant for liability. Our general terms and conditions apply, which can also be found