INTEGRATED TELEMETRY SYSTEM TWO-WAY COMMUNICATION ON REMOTE EQUIPMENT FEATURES The unit works with electronic engine controllers, ECU's, devices on a CANbus, devices connected via Modbus RTU and direct connections to digital and analog signals Pre-configured to monitor and report standard CANbus engine messages Daily fuel rate, maximum and minimum values of all engine parameters are automatically reported Engine diagnostics are filtered to eliminate excessive reporting on intermittent faults Supports multiple CANbus speeds, multiple devices on a single CANbus and reading and writing (for OEMs) Supports up to four digital inputs for detecting on/off conditions or used as pulsing inputs (e.g. flow meters) Three analog inputs for current or voltage inputs, reported as raw data or converted to engineering units Two output relays controlled manually or automatically based on analog values exceeding thresholds or digital inputs changing state Independent Modbus master and slave communication over two serial ports Backend reporting via UDP or TCP using proprietary protocol The Satellite modem option enables coverage in hard-to-reach areas around the globe Easily activate and link to your BLE with the RemoteIQ™ Messenger BLE app from any mobile device Diesel engines Generators Supported Modbus functions include 16-bit and 32-bit versions of: register, coil, float and packed-digital reads and writes Smart contro

Messenger BLE TECHNICAL DATA AND SPECIFICATIONS Non-CANbus Conditions GPS coordinates for location General purpose or pulse closure-to-ground inputs Analog inputs for external sensors Geo-fencing Pre-Configured CANbus Parameters From One or More ECUs Engine hours RPM Battery voltage Oil pressure, temp and level Fuel level Coolant level and temperature Odometer Throttle and accelerator position Air filter differential pressure Ambient conditions Diagnostic messages reported via DM1 Fault conditions OEM-specific parameters Daily fuel usage and hours Trip fuel usage and hours Idle time-limit exceeded...