Number and diameter of rollers 9,71.1 cm (28 in) Take-up tumblers diameter 147.3 cm (58 in) Dipper payload 38 tonnes (42 tons) Effective length of dipper handle 8.2 m (26 ft 10 in) Overall length of dipper handle 9.9 m (32 ft 6 in) Working weight, with dipper, without ballast or dipper 545 290 kg (1,202,160 lbs) General-purpose dipper Ballast (furnished by customer) 140 616 kg (310,000 lbs) • These weights will vary slightly depending upon dipper and optional equipment selection Main Structures Crawler Mounting_ Overall length of mounting 10.26 m (33 ft 8 in) Total effective bearing area 21m2 (224 ft2) Number and pitch of treads 96, 45.1 cm (17.75 in) Planetary Propel_ Dual-motor independent drive Revolving Frame (Center Section)_ Welded impact-resistant steel Length: 11.18m (36 ft 8 in) Cast alloy steel swing rack Teeth external cut 29.21 cm face (11.5 in) Tapered, forged alloy steel roller rails diameter 4.04 m (13 ft 3 in) Number of tapered rollers 45 Tapered rollers diameter 22.86 cm (9 in) Two planetary gearboxes, each driven by a vertically mounted variable-speed AC motor, located on either side of the revolving frame towards the front of the machine. Single-output pinion shaft from each gearbox engages the swing rack Double-reduction, conventional gearcase driven by a variable-speed Lube System_ • PLC-controlled, air-operated, three 208 liter (55 gallon) drum reserves • Divided into three systems: open gear lube, upper works grease, and lower works grease • Faults protection: low pressure and vent release

Optimal Working Ranges Aj Dumping height at maximum electric crowd limit 6.1 m (20 ft 1 in) B Dumping radius (maximum) 17.5 m (57 ft 5 in) C Cutting height (maximum) 15.6 m (51 ft 4 in) D Cutting radius (maximum) 20.7 m (68 ft) E Radius of level floor 14.7 m (48 ft 1 in) (boom point sheaves) 15.9 m (52 ft 3 in) (boom point sheaves) 15.2 m (49 ft 9 in) J Clearance under frame (to ground) 0.8 m (2 ft 6 in) M Clearance under lowest point in truck frame/propel gearcase 0.8 m (2 ft 6 in) IGBTAcutrol drive system Power Requirements_ • Other voltage requirements available to suit customer requirements...

Electric Rope Shovel—7295 HD Front End Boom Boom Boom point sheaves Boom point sheave diameters Handle diameter single stick Wall thickness (nominal) ASTM A678 grade C quench and temper carbon steel twin-grooved, flame-hardened cast steel 1.7 m (5 ft 6 in) 0.6 m x 1.04 m (2 ft x 3 ft 4.75 in) 3.81 cm (1.5 in) top, 4.45 cm (1.75 in) bottom, 3.175 cm (1.25 in) side Rope Data Hoist No. Diameter 2 Boom susp. 4 Dipper trip 1 50.8 mm (2 in) Type Construction twin dual 6x41 69.8 mm (2.75 in) 12.7 mm (.5 in) 6x37 6x37 Crowd Single stick rack-and-pinion system - a boom-mounted AC motor drives double-reduction...