*mydirectindustry

Catalogs
C.A.Technologies
Lynx 100C (L100C)

Lynx 100C (L100C)

Product catalog summary

Overview: This document provides technical specifications, operational procedures, and maintenance instructions for the L100C Conventional Spray Gun, including a detailed chart of air cap and fluid nozzle combinations.

Specifications:

The spray gun supports various air cap and fluid nozzle combinations, with fluid tip ranges from 0.6mm to 2.8mm.
Materials used include 17-4PH stainless steel and carbide for durability.
Air cap models are specified with different SCFM ratings and fan control capabilities.

Operation Instructions:

Connect the air supply hose to the gun handle and attach a pressurized fluid supply or paint siphon cup to the fluid inlet.
Adjust fluid flow using the fluid control knob and select the appropriate fluid orifice size for optimal performance.
Fan width is adjustable via the fan control knob.

Maintenance Guidelines:

Routine cleaning is essential; use a covered gun cleaner where required by law.
For cleaning without a gun cleaner, remove the air cap and clean separately with solvent.
Disassembly of the gun head is not recommended for regular maintenance.

Disassembly and Reassembly Instructions:

Detailed steps are provided for removing and reinstalling components such as the nozzle carrier, air cap adapter, and fluid inlet.
Torque specifications are given for tightening various components during reassembly.

Parts List:

A comprehensive list of parts with item numbers and descriptions is included, indicating which parts are available in the repair kit #10-106.

Fluid Nozzle/Air Cap Selection:

Charts provide guidance on selecting the appropriate fluid nozzle and air cap combinations based on material type and viscosity, measured in Zahn seconds.
Recommendations are given for different material types, including very thin inks and dyes, thin lacquers and enamels, medium automotive coatings, and heavy body primers.

Catalog excerpts

Lynx 100C PRESSURE/SIPHON FEED SPRAY GUN PRODUCT INFORMATION CONVENTIONAL AIR CAP AND FLUID NOZZLE CHART MODEL NO. PRESS / SIPHON AVAILABLE FLUID NOZZLES NEEDLES/ marking on needle Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) Gun inlet pressures may vary as required by application 200 Air cap requires P/N 21-1583 base & 21-1584 ring Coating Atomization Technologies 337 South Arthur Avenue, Louisville CO 80027 Phone: 888.820.4498, Fax: 303.438.5708 _www.spraycat.com_

Open the catalog to page 1

Operation and Maintenance Instructions for Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply or paint siphon cup to the gun fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice size and use the fluid control knob to “fine tune flow rate”. 4. Fan width can be adjusted using the fan control knob. Turning the knob clockwise narrows the fan. Maintenance IMPORTANT! Routine cleaning and maintenance is essential...

Open the catalog to page 2

Fluid Nozzle Body Nozzle Body Carrier Lynx Gun Body Conventional Allen Plug Rear Bushing Fluid Needle* Needle Return Spring* *See air cap selection chart on page 1 Indicates part included in repair kit # 10-106

Open the catalog to page 3

All C.A.Technologies catalogs and technical brochures

Archived catalogs

Catalog 2007
35 Pages

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list