Catalogs >
C.A.Technologies >
H2O-CPR-G

H2O-CPR-G
4Pages

Catalog excerpts

H2O-CPR-G GRAVITY FEED SPRAY GUN PRODUCT INFORMATION The H2O-CPR-G gun comes equipped with both a pressure reduced air cap 23-2101 and a HVLP air cap 23-1301 for areas requiring HVLP compliance. 23-2101 - consumes 11 cfm at 29 psi gun inlet. 23-1301 - consumes 13.5 cfm at 29 psi gun inlet. 23-2101 pressure reduced air caps can be used with the 0.8 mm - 1.7 mm fluid orifices listed below. 23-1301 HVLP air caps can be used with the full range of fluid orifices listed below. HVLP/PRESSURE REDUCED AIR CAP AND FLUID NOZZLE CHART MODEL NO. *MAX GUN FLUID TIP INLET PRESS. RANGE FOR HVLP AVAILABLE FLUID NOZZLES TIPS 33-0208 33-0210 0.8 - 1.7 29* 11 33-0212 G, PPS 33-0213 H2O-CPR-G 60-1504 (S) 33-0214 G, PPS 33-0215 23-1301 G, PPS 33-0217 0.8 - 2.2 29* 13.5 (HVLP) 33-0219 33-0222 Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Note: Air cap test gages are available to confirm HVLP compliance. *Gun inlet pressures may vary as required by application 23-2101 CPR (Pressure Reduced) Coating Atomization Technologies 337 South Arthur Avenue, Louisville CO 80027 Phone: 888.820.4498, Fax: 303.438.5708 www.spraycat.com

Open the catalog to page 1

Operation and Maintenance Instructions for Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Screw the paint cup onto the gun’s gravity feed fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice size and use the fluid control knob to “fine tune flow rate”. 4. Fan width can be adjusted using the fan control knob. Turning the knob clockwise narrows the fan. Maintenance IMPORTANT! Routine cleaning and maintenance is essential to insure...

Open the catalog to page 2

**See air cap selection chart on page 1 indicates part included in repair kit # 10-105

Open the catalog to page 3

H2O-CPR-G Includes: 51-401 700 mL Aluminum Gravity Cup 98-0113 Gun Cleaning Brush Air Caps and Needles Shown on Page 1 H2O-CPR-G-PPS Includes: 91-465 650 mL PPS™ Cup and Collar 91-466 Lids and Liners (Available in 50 Pack) 98-0113 Gun Cleaning Brush Air Caps and Needles Shown on Page 1 Air Caps and Needles Shown on Page 1 EP-H2O-CPR-G-PPS Includes: 91-465 650 mL PPS™ Cup and Collar 91-466 Lids and Liners (Available in 50 Pack) 98-0113 Gun Cleaning Brush Air Caps and Needles Shown on Page 1

Open the catalog to page 4