Catalogs >
C.A.Technologies >
C-20 AAA FINE FINISH SERIES PUMP OUTFIT

C-20 AAA FINE FINISH SERIES PUMP OUTFIT
4Pages

Catalog excerpts

C-20 AAA FINE FINISH SERIES PUMP OUTFIT - 1

PRODUCT INFORMATION C -20 AAA FINE FINISH SERIES PUMP OUTFIT The C-20 pump is designed to deliver coating materials to multiple Air Assist automatic or hand spray guns. With a pressure ratio of 20:1 and up to 2 gpm flow, the pump can support up to eight guns with .013 orifices. Training videos are available at: http://www.spraycat.com/trainingvideos.html IMPORTANT! READ THE HAZARD WARNING INFORMATION AIR ASSIST AIRLESS OPERATES WITH FLUID PRESSURES UP TO 1500 PSI AND CAN CAUSE SERIOUS INJURY IF IMPROPERLY USED. EVERYONE USING THIS EQUIPMENT MUST READ AND FULLY UNDERSTAND THE SAFETY WARNINGS. C.A.Technologies 337 S. Arthur Ave. Louisville, CO 80027 www.spraycat.com

Open the catalog to page 1

C-20 AAA FINE FINISH SERIES PUMP OUTFIT - 2

SU C-20 AAA Fluid section 74-200-X1X2 i i MP ‘S” - Self Adjusting “M”- Manual Take up ITEM NO. Ball Cage Lower Pump Tube Lower Bushing Upper Pump Tube Locking Ring Coupling Tube Coupling Tube (V-Packing Set) Sight Glass 74-200 FLUID SECTION ASSY 9/2/10 ‘Indicates item in repair kit # 10-150=74-200-SU, 10-151=74-200-SP,10-152=74-200-MU, 10-153=74-200-MP

Open the catalog to page 2

C-20 AAA FINE FINISH SERIES PUMP OUTFIT - 3

Snap Ring Trip Rod Seal Cartridge Assembly Cylinder Head Spool Seat Upper Valve Body Center Valve Body Cylinder Head Magnet Assembly Lock Washer O-Ring (Material = BUNA-N) Valve Spool Motor Rod Seal Cartridge Assembly Spool Spacer Coupling, Seal Retainer Spool Shuttle Lock Washer Snap Ring Trip Spacer Trip Spring *Indicates item in repair kit # 10-149

Open the catalog to page 3

C-20 AAA FINE FINISH SERIES PUMP OUTFIT - 4

HAZARD WARNINGS General safety The C-20 AAA system is intended to be used by professional personnel only. Everyone using this equipment should read and understand all safety warnings. Do not exceed the maximum working pressure of this equipment. MAXIMUM WORKING PRESSURE IS 1500 PSI FLUID PRESSURE (107 psi to air motor). Do not modify this equipment. Always relieve fluid pressure to 0 psi before preforming maintenance. Make sure all fluid connections are tight before operating this equipment Operate this equipment only in a well ventilated area to prevent build up of toxic and or flammable...

Open the catalog to page 4