AutaCAT 100C AUTOMATIC SPRAY GUN PRODUCT INFORMATION CONVENTIONAL AIR CAP AND FLUID NOZZLE CHART MODEL NO. PRESS / SIPHON AVAILABLE FLUID NOZZLES NEEDLES/ marking on needle Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) Gun inlet pressures may vary as required by application 200 Air cap requires P/N 21-1583 base & 21-1584 ring Coating Atomization Technologies 337 South Arthur Avenue, Louisville CO 80027 Phone: 888.820.4498, Fax: 303.438.5708 _www.spraycat.com_

Operation and Maintenance Instructions for Spray Guns Gun Mounting A 1/2” dia. x 5” lg. rod is provided for mounting. The gun can be mounted from the left or right side or from the bottom. Thread the mounting rod (9) into one of the three holes that best suit the mounting location for the application. Tighten the locknut (10) to secure the gun in the position desired. Do not plug the remaining holes as they are used as drain holes in the event of a needle seal leak. Operation: Connections and Adjustments The automatic gun requires two separate regulated air supply lines. 1. Connect one air line...

O-Ring (Viton) 2 Required* O-Ring (Viton) 2 Required* O-Ring (Viton) 2 Required* Fluid Inlet O-Ring (Teflon)* O-Ring (Viton)* Piston Return Spring Needle Assembly Needle Return Spring Locknut - Fluid Control Knob Fluid Control Knob Indicates part included in repair kit # 10-107 *See air cap selection chart on page 1 l**Air inlet fittings are available in 90 degree elbow . 90 degree elbow tubing "push on" style fittings P/N 53-520 1/8 NPT x 1/4" OD Tube P/N 53-521 1/4 NPT x 3/8" OD Tube