Catalogs >
Cat Lift Trucks >
MEDIUM- & HIGH-LEVEL ORDER PICKERS

MEDIUM- & HIGH-LEVEL ORDER PICKERS
8Pages

Add to favorites

Catalog excerpts

PRELIMINARY SPECIFICATIONS MEDIUM- & HIGH-LEVEL ORDER PICKERS 24/48V 1.0 - 1.25 TONNES

Open the catalog to page 1

TOP RESULTS IN HIGH RACKING OPTIMISE THE BENEFITS OF NARROW AISLES AND HIGH RACKING WITH ONE OF THESE MEDIUM- OR HIGH-LEVEL ORDER PICKERS. BASED ON THE SAME RUGGED, MODULAR, LOW-MAINTENANCE DESIGN, THEY ARE SPECIFIED FOR MAXIMUM OUTPUT AND PROFITABILITY. Heavy duty 48V NOH12PH reaches picking locations as high as 12.1 m and has an unequalled 1.25 tonne capacity. Pick height for 24V NOM10P goes up to 9.85 m. Advanced, user-friendly interface features a right-hand control unit providing excellent anatomical fit, positional adjustment, grip and support, for comfortable and precise operation....

Open the catalog to page 2

• Rugged modular design extends truck life and simplifies replacement of parts. • Two-piece control panel is integrated into chassis for a shorter, more compact truck design with more operator space. • Latest AC drive motor technology provides greater torque, efficiency and control, with minimal maintenance. • PIN code log-in prevents unauthorised use. • ATC t4 onboard computer and display enables clear status information and fault warnings, quick diagnostics and easy driver settings. • ECO mode can be selected to slow operation slightly while saving significantly (about 5-6%) on energy...

Open the catalog to page 3

STANDARD EQUIPMENT AND OPTIONS NOM10P GENERAL Micro-computer incl. Hour meter and battery indicator Drive and lift controls on mast side Operators presence sensor in floor Cornering control Two hand operation in guided aisles Platform with LiftComfort and fixed forks SecurGate gates Warning light Display incl. Steering wheel indicator GUIDANCE Rail guidance Wire guidance DESCENDER DEVICE Descender device High specification escape device ENVIRONMENT Chill store design, with rust protected axles Cold store design, 0C° to -35C° DRIVE, LIFT CONTROLS On fork side On fork and mast side Extra...

Open the catalog to page 4

Ast = Working aisle width x = Load wheel axle to fork face This specification sheet provides details of the standard truck specification in accordance with VDI Guideline 2198.

Open the catalog to page 6

h12/3+770 5785-10285 h12+2160 2356 215-h12 175 775 6000-10500 90 3290 2139 1170/1350 "70/147/1 150" 560 450-800 1348-1814 25 Platform or load width + 90mm clearance/each side 2020 Working aisle width V(l6 + x)2 + ( b12 / 2)2+a Turning radius Pallet length Load wheel axle to fork face b1/b2 = Overall width a = Safety clearance = 2 x 100 mm This specification sheet provides details of the standard truck specification in accordance with VDI Guideline 2198.

Open the catalog to page 7

Load deration based on load evenly spread along the forks Load deration on request when LC >600 mm mL = is ground clearance Standard lift heights are limited by truck width. Therefore residual capacity is shown at maximum standard lift height for the relative truck width. B = is chassis width. Other higher options may be available but subject to special design Mast Performance and Capacity h1 Closed mast height h12 Lift height h Fork height LiftComfort raised B Chassis width Q Lifting capacity, rated load c Load centre (distance) ( ) = Non standard mast, only to show capacity Load deration...

Open the catalog to page 8