CONSTRUCTION crawler dozer LT/WT/LGP TIER 3 CERTIFIED OPERATING WEIGHT Emissions Certification Fuel injection Common rail Fuel filter Spin-on w/ in-line strainer Engine speeds High idle - no load Rated - full load Low idle Dual path hydrostatic: Pump Variable axial piston Motor Variable bent axis piston Transmission Single lever control - electronic straight tracking Transmission oil filter 4 micron, spin-on Parking brakes Heavy-duty, spring-applied, hydraulic pressure release Steering brakes Hydrostatic Final drive 2 helical gear reduction to planetary output Ratio6H Transmission cooling: Type Oil to air NOTE: *Measured using standard track chain. Increase travel speeds by 4% and reduce drawbar pull by 4% with the optional CELT track chain. Unit equipped w/ ROPS, full fuel tank, 170 lb (77 kg) operator, track guides, backup alarm, horn and lights. Long track 16,250 lb (7 370 kg) Wide track16,800 lb (7 619 kg) Low ground pressure 17,550 lb (7 959 kg) Add-on weights: Drawbar Ripper - 3 shank Winch Front counterweight Cab CELT chain Center rockguard Sweeps Dual batteries 90 in blade 96 in blade 109 in blade 120 in blade CLT w/ 16 in closed shoe CELT w/ 16 in open shoe CLT w/ 20 in closed shoe CELT w/ 20 in open shoe CLT w/ 27 in closed shoe CELT w/ 27 in open shoe Engine lubrication: Pump Deep sump plate cooler w/ pressurized under-piston nozzles Pump operating angle ratings: Side-to-side 45° 700 cold-cranking amps @ 0° F (-18 C) Electrical system 12 Volts Pump flow @ 2000 RPM @ 3,000 psi (20 684 kPA) 20.3 gpm (78.8 L/min) OPERATOR ENVIRONMENT Lift cylinder Bore diameter Rod diameter Stroke Oil filtration Replaceable, spin-on Optional ROPS cab; Single lever control for speed, steering and direction; Forward/reverse speed ratio selector; Adjustable armrests; Foot rests; Retractable seat belt, 2 in (51 mm); Vinyl suspension seat w/ back adjustment; Rear view mirror. Warning lights: Air filter; Alternator; Engine oil pressure; Hi range; Hydraulic filter; Transmission filter; Transmission pressure. Gauges: Battery voltage; Fuel level; Hour meter; Tachometer; Transmission oil temperature; Water temperature. Audible warnings: Engine oil pressure; Transmission pressure. Angle cylinder Bore diameter Rod diameter Stroke Tilt cylinder Bore diameter Rod diameter Stroke SERVICE CAPACITIES Engine cooling system 22.6 qt (21.4 L) Final drive - per side 15 qt (14.2 L) Track rollers - each 0.19 qt (0.18 L) Front idlers - each 0.42 qt (0.40 L) Carrier rollers - each 0.25 qt (0.24 L)

Undercarriage: Track adjustment Frame Length of track on ground: Track link pitch Track shoe height Pin diameter Bushing diameter: CLT track CELT track Bolt diameter Track shoes per side Track rollers per side Carrier rollers per side Track roller rail diameter Blade: Variable blade pitch 52° - 60° Lift speed - per second 19.7 in (500 mm) Cutting edge Reversible, replaceable closed grousers and CLT open grousers and CELT closed grousers and CLT open grousers and CELT closed grousers and CLT open grousers and CELT closed grousers and CLT open grousers and CELT Ripper: Max. penetration Width Cut...

Case Family IV 445TA/EG7a diesel Tier 3 Certified Automatic fan belt tensioner Integral engine oil cooling Fuel filter Dual element radial seal air cleaner 90 amp alternator 700 CCA 12-volt battery Engine side panel Anti-freeze to -34°F Pusher fan Dual path infinitely variable, single-lever controlled hydrostatic drive with electronic straight tracking & counter-rotation, 4-position forward/reverse ratio control Final drive: Triple reduction; helical gear/planetary decelerator with hydrostatic drive retardation Automatic spring-applied parking brake 10 incremental speed settings - Operator preference...