TECHNICAL DATA SHEET - CST 01020/02 - 16/01/2018 PLANIFLEX PF 65 BASIS Glass fibers, NBR. GENERAL PROPERTIES AND APPLICATION Gasket material with excellent torque retention and good steam and thermal resistance. Suitable for use with water, oil, gasses, fuels, organic and inorganic acid. PLANIFLEX PF 65 Typical value thickness 2.0 mm Compressibility ASTM F36 Peak Temperature Continuous Temperature Continuous Temperature with Steam Tensile strength DIN 52910 Thickness increase ASTM F146 Pressure Bar / psi Available sizes : (mm) 1.500 x 1.500 and 1.500 x 3.000; (inch) 60” x 60” and 60” x 120” Available thickness: (mm) 0,50 ÷ 0,80 ÷ 1,0 ÷ 1,5 ÷ 2,0 ÷ 2,5 ÷ 3,0 ÷ 4,00 ÷ 5,00; (inch)1/64” ÷ 1/32” ÷ 3/64” ÷ 1/16” ÷ 3/32” ÷ 3/32” ÷ 1/8” ÷ 3/16” ÷ 7/32”; other thickness available on demand. Temperature and pressure represent maximum values and should not be used simultaneously. They are given only for guidance, since they depend not only on the type of gasket material but also on the assembly conditions. Very important factors are: thickness of material, nature of service medium, type of flange, surface stress. Steam application requires special consideration. Carrara S.p.A., Via Provinciale 1/E 25030 Adro - BS – Italia - tel. +39 030 7451121 – fax +39 030 7451130 - http://www.carrara.it - [email protected] CARRARA S.p.A. declines any responsibility for damages to things and persons coming from an improper use of own products. CARRARA