Wireless Smart Actuator 1 or 4 relays Wireless Actuator Technical Information Power Supply One or four relays wireless actuator. Wireless actuator to command up to 8A charges. Suitable for centralize the management of different thermal adjustment rings in wireless mode. Therefore, remotely, the relay's status can be readed and commands can be issued. Two models available: one single pole, double throw relay output (WSA02R1) one single pole, double throw relay output and three single pole, single throw relays output (WSA02R4). Using proper configuration parameters for each channel, is also possible setup in advance the relay behaviour in offline conditions: • OPEN (put the relay in "OPEN" status) • CLOSE (put the relay in "CLOSED" status) NULL (maintain the current relay status) The radio module based on WINECAP™ protocol provides an excellent radio range and a very low battery consumption. With a backup memory onboard may store the last 64.000 samples per channel even if the wireless link is down that can be downloaded using a USB connection. The actuator may be interfaced with: • all the basestations of MWDG product line • all the basestations of MWLI product line All the functional parameters are modifiable in real time, using the configuration software and/or using the basestation's modbus interface. If necessary, radio range may be extended using up to 32 WR11 routers (maximum 16 for each path) between the datalogger and the basestation. The features shown may be subject to change without notice.