Catalogs >
Cannon Spa >
FPL AN Mixing Head: three component high pressure head with axial injection of a third non abrasive component

FPL AN Mixing Head: three component high pressure head with axial injection of a third non abrasive component
2Pages

Catalog excerpts

FPL AN Mixing Head: three component high pressure head with axial injection of a third non abrasive component - 1

FPL AN [Axial Needle] Head Three components high pressure mixing head designed for the axial injection of a third , non abrasive, component (fillers with no quarz). In case of axial injection of a low viscosity stream, excellent mixing is obtained also at lower pressure. All three streams are recycling through the head. The mixhead is patented. Recycling phase Flow [cc/sec] Pouring phase WORKING AREA Axial Stream - cc/sec Min. output Max. output Axial Stream - FPL 18 HP AN 3 components - Filler on axial stream1 FPL 24 HP AN 3 components - Filler on axial stream1 cc/sec Min. output Max. output cc/sec Min. output Max. output FPL 18 AN 3 components - NO filler on axial stream1-2 FPL 24 AN 3 components - NO filler on axial stream1-2 cc/sec Min. output Max. output cc/sec Min. output Max. output (1) Axial stream output has to be < or = to the pure polyol stream output by weight. (2) Axial stream: color, additives or any other component without fillers (*) Axial stream viscosity < 4000 cps at 150 bar. Pherical fillers with granulometry < 100 micron. Lamellas fillers with dimension < 500 micron For higher viscosity see diagram (flow - viscosity) POLYURETHANE TECHNOLOGY cc/sec Min. output Max. output

Open the catalog to page 1

FPL AN Mixing Head: three component high pressure head with axial injection of a third non abrasive component - 2

All data are subject to variation without notification due to continuos technical/technological developments Via Galileo Ferraris, 65 - 21042 Caronno P.lla, (VA) Italy - Tel. +39 0296531 - www.afros.it Afros Division

Open the catalog to page 2