LeakVIEW Manual Visual detection of packaging leaks through either bubble emissions or burst testing. The LeakVIEW is an ideal seal integrity tester for a range of packaging within the food, consumer and medical device industries. Enhanced by its clear Perspex test chamber, the LeakVIEW provides optimum visual detection of leaks. User-friendly and low maintenance, the system is able to identify holes smaller than 20 microns and can operate in compliance with ASTM D3078 or ASTM F2096 standards. When carrying out bubble emissions testing, the chamber is filled with water. During the test phase, the head-space is placed under a vacuum, causing the inserted packaging to inflate. Should any leaks be present, a stream of bubbles will be emitted. Water is not required for altitude simulation or burst testing. Operated by a simple Selector lever that rotates to hold the vacuum at a chosen level, and then further rotates to control the vent rate. No specialist tooling, electrical connection or calibration is required to operate the system. An alternative option to manual operation of the system is the fully programmable LeakVIEW Controller. Custom configurations are available to tailor the LeakVIEW to each individual’s requirements. A range of sizes are available, in addition to an internal pressurisation option (ASTM F2096 conformant). An essential piece of equipment for any packaging facility, the LeakVIEW is fundamentally able to test any sealed packaging component with a head space. configurable customer LeakVIEW range possesses a number of standard features to enhance functionality. Bubble emission testing Dry vacuum burst testing Internal pressurisation option Manual or automated control

Food Packaging - e.g. crisps, snacks, coffee, dairy, meat and fruit & vegetables Medical Devices - e.g. blister trays, testing kits, implants and pouches Consumer Products - e.g. cleaning, pet, sexual health, toiletries and cosmetics Dynascan. Unit 29 Stephenson Road, St Ives, Cambs, PE27 3WJ, United Kingdom Due to continuous product development necessary changes to specifications may be made without prior notice. Issue no: V1-2018