S06 MODEL HSM30・HSM30F Hall effect IC • Bushingmount • RoHS Compliant ● Hall effect IC ● Bushingmount ● RoHS Compliant 3 Leadwire(AEX 0.5SQ) of abt.300mm (4 wires at dual output. 6 wires at dual independent ouput) Note:1) The drawings show the position of shaft flatted at the ratio value of 50%. 2) 1 pc.each of inner teeth washer and hex nut are attached. 3) Please duly note that inner construction may burn out when applying the voltage to the wrong terminals except input terminal. Contactless type Note: The difference between S06A and S06B is with or without flange only. The following performances are the same. ● General Specif ications ● Environmental Specif ications Independent Linearity Tolerance Mechanical Rotating Angle Thermal Shock Exposure at High Temperature Current Consumption Single output: Max. 16mA Dual output: Max. 32mA Effective Electrical Angle 360°(Endless) Applied Voltage Load resistance Rotational Life Expectancy Approx. 50,000,000 shaft revolutions Effective Output Output Temperature Characteristics ±8kV contact discharge /±15kV aerial discharge (Based on IEC 61000-4-2) Operating Temperature Range Storage Temperature Range Rotating Torque （Note）Rotational Life Expectancy may differ from the specifications depending on status of use. ● Terminal Connection Diagram OUT A OUT B (In case of a parallel output) Single output Output Voltage Dual output Dual Independent output OUT B (In case of a crossing output) ● Special Specifications Available (In case of the potentiometer with special specifications, the general specifications and environmental specifications may change. Please consult us in advance.) ● Special effective electrical angle (90° ,180° ,270° arbitrary angles) ● Special output (Cross, parallel, Dual independent output) ● Special machining on the shaft ● Special applied voltage (12V,24V) ● Low current consumption in slow mode CALDARO AB • HQ Stockholm Sweden, +46 (0)8-736 12 70