Catalogs >
CABLE EQUIPEMENTS >
Unwinders 1T200

Unwinders 1T200
1 / 2Pages

Catalog excerpts

Roller unwinder Gamme 0T200 des dérouleurs à rouleaux classiques The classic one with a low price - Mechanical welded monoblock frame with integrated ramp - 2 fixed rolls, welded to the frame (Ø 70 mm, length 540 mm) - Welded cups on roller edges to hold the cable drum - Max width of the cable drum: 520 mm 0T800 1T200 - Mechanical welded monoblock frame with integrated ramp - 2 fixed rolls, welded to the frame (Ø 70 mm) - Waterproof bearings - Welded cups on roller edges to hold the cable drum - System for locking the front roller for easing the unloading operations - Max width of the cable drum: 575 mm 5à7T 20210503 Document et photos non contractuels The cable drum unwider is made of 2 shoes which are mechanically welded and linked by 2 square tubes, secured by split pins. Each shoe is equiped with: - 2 rolls, heavy load, Ø 89mm, length 235mm. The front roller is stationery, the rear roller can be adjusted acording to the diameter of the cable drum - System for locking the front roller for easing the unloading operations - Removable ramp - Guide roller at side - Carrying handle - Max width of the cable drum: 1350 mm

Open the catalog to page 1

Roller unwinder 7 à 10 T With hydraulic lifting The cable drum unwider is made of 2 frames which are mechanically welded. Each frame is fitted with 2 rolls, heavy load, Ø 89mm, length 235mm, each one secured in a shoe. The set (shoes + rear roller) can be removable to allow the setting of the drum; once it's done, it is later out back in place , the closest to the drum and secured by pins. The set (shoes + front roller), is pushed by an hydraulic jack with a 10 tons force ( manual pump action) and this generates the lifting of the drum from the ground. Guide roller at side onto the rear...

Open the catalog to page 2