Catalogs >
CABLE EQUIPEMENTS >
STEEL 800 Range

STEEL 800 Range
4Pages

Catalog excerpts

The most complete range for the most demanding industrial uses - Length: - Cables: up to 55 meters from 1 to 25 conductors from 1 mm2 to 25 mm2 - Collector: - Degree of protection: - Operating temperature: - Maximum winding speed: - Collector insulation voltage: - Housing: - Winding spring: up to100A IP65 -5°C/+50°C 30 m/minute 2.5 kV open in varnished steel and aluminum made of high quality steel, long-lasting The reels are delivered with: - power supply side cable, length 2.50 meters - anchor sock adapted to the cable. The reels are delivered with cable. All models are available without cable (ERSC code, etc.), contact us. Cable installation is the responsibility of the customer. Provide electrical protection upstream of the reel taking into account the most unfavorable situation (coiled cable). The cable should enter the center of the cable guide, without sharp corners or friction. How to choose the right model? Given the technical nature of this range, it is recommended to ask yourself the following 3 questions, then consult us to define the appropriate model and the necessary options: 1 ) Which reel? - number of conductors / section / power? - length ? 2 ) What type of cable unwinding? - horizontal unfolding? - vertical unwinding (fixed to the ceiling or fixed to the floor)? - mobile reel or unwinding in 2 directions? 3 ) What type of cable pulling? - manual cable pulling (by an operator)? - mechanized cable pulling? Unwinding type Cable Pulling Type - S8H models are only suitable for horizontal unwinding. - The S8V models are suitable for horizontal unwinding and vertical unrolling. - For vertical unwinding, the fixed flange is mandatory - If the reel is mobile or unwinds in 2 directions, the rotating arm (codes ERXS8-04 or ERXS8-08) is mandatory. In this case, the pawl is excluded. Safety Return, which slows down and secures the winding is strongly recommended in the event of manual pulling. It is not suitable for mechanized pulling (gate, crane, overhead crane, etc.) “Turnkey” models Models on yellow background in the table below. These models are available from stock. For the sake of simplicity, they are offered turnkey, fully equipped: - always with roller cable guide - always with ratchet (removable) in several versions: - with Safety Return (if manual pulling) or without Safety Return (if mechanized pulling) - with fixed flange (compulsory if vertical unwinding) or with pivoting flange. The flanges are delivered disassembled. 20231025 - Document etphotos non contractuels Models to configure For other models, once the reel is defined, you must add the necessary options: - flange (fixed or pivoting) - guide / ratchet -Safety return - rotary guidance in function : - the type of progress - the type of draw. Please note, not all options fit on all models: refer to the table below.

Open the catalog to page 1

STEEL 800 range Equipment standard on “Turnkey” models optional on other “configure” models According to table below − − Safety Return Swivel flange Slows down and secures winding Highly recommended if manual draw Can only be installed during manufacturing Horizontal use Wall mounting Cable guide / Stopper Fixed flange Wall, floor or ceiling mounting Horizontal and vertical use Mandatory if vertical use Rotating arm Unwinding in 2 directions or mobile reel. Can only be installed during manufacturing 20231025 - Document et photos non contractuels

Open the catalog to page 2