SATELLITE® The solution for cable and sheath coils - Unwinding a coil is a real problem on the sites: either the plastic film is retained and one gets a completely twisted “pigtail” ; or it is removed and then it becomes difficult to recover the coil at the end of the day. - With SATELLITE, one can keep the blister packaging: the rotation of the tray prevents the cable from getting twisted. - With a large diameter of 750 mm, SATELLITE is well suited for both cables and sheaths, pre-wired or not. - Made of galvanised steel, SATELLITE is incredibly resistant. - Stability is ensured by a weighted base and 3 welldistanced legs. - The position of the vertical spindles (height: 300 mm) can be adjusted for properly maintaining the coil from the interior (from 140 to 230 mm). - Unfolded dimensions: Ø 750 x h 440 mm Patented model Can be fully dismantled - A coil holder with such a diameter would be of no use if it cannot be dismantled: it only takes a couple of seconds to assemble or dismantle SATELLITE. - All of the parts (central part, 3 legs, 3 bars, 3 vertical spindles) can be packed in a bag which can be carried over the shoulder, thus leaving one’s hands free. - Weight: only 8.3 kg Can also be used with small cable drums Document et photos non contractuels - By removing the vertical spindles. - Very useful for horizontal unwinding when the flanges of the cable drum are broken. - Central shaft diameter: 25 mm, height: 330 mm. Video click here