Load Bending Beam Model 8511 - 2 Pages

Add to MyDirectIndustry favorites
Load Bending Beam Model 8511

Catalog excerpts

Code: Delivery: Warranty: Application Model 8511 bending beam load cells are designed for measuring tension and compression forces. Their high accuracy, low torque sensitivity and very low mounting height make these sensors particularly suitable for use in weighing and dosing technology as well as for laboratory and production use. Extremely simple force application makes the sensor easy to handle. It offers a very favorable price/performance ratio and can be used universally for static and dynamic measurements. Examples of application: ► Dosing system ► Load deflection curve ► Tension force measurement for wire or thread winders ► Friction forces ► Cable force ► Withdrawal force, etc ■ For tension and compression forces ■ Measuring ranges from 0 ... 5 N to 0 ... 2000 N ■ High linearity up to 0.1 % ■ Very low mounting height ■ Simple force application ■ Material aluminium or stainless steel ■ Special design on request Description The measuring element of this load cell consists of a double bending beam with strain gauges, the resistance of which changes with the application of force. Upon applying a voltage to the strain gauge bridge, the change in the strain gauge resistance is converted into output voltage, which is directly proportional to the force. The strain gauges and the entire measuring element are protected from water spray by rubber bellows. To install the load cell, it is securely clamped on the side with 2 bore holes. The tension or compression force to be measured is applied at the other end. Force is applied easily perpendicular to the sensor axis. This serves to prevent falsification of the measured values. The influence on the measuring signal resulting from the increase of load distance on the mounting side (e.g. by a touch finger) is negligible. Overload protection can be realized with little effort using a mechanical stop. Technical changes reserved. All data sheets at www.burster.com burster praezisionsmesstechnik gmbh & co kg Germany www.burster.com Talstr. 1-5 ■ Gernsbach 76593 ■ Phone +49-7224-6450 info@burster.com

 Open the catalog to page 1

* Combined value consisting of non-linearity, hysteresis and nonrepeatability in constant installation position. positive negative positive negative excitation excitation signal output signal output Electrical values Bridge resistance: full bridge, foil model strain gauge 350 Q, nominal Excitation voltage: up to range 0 ... 20 N over range 0 ... 50 N Sensitivity: up to range 0 ... 20 N over range 0 ... 50 N Shunt calibration resistance: 100 kQ ± 0,1 % The bridge output voltage evoked by a shunt of this value is indicated in the calibration protocol. * Deviations from the stated values are...

 Open the catalog to page 2

All Burster präzisionsmesstechnik gmbh & co kg catalogs and technical brochures

  1. Digital Display

    4 Pages

  2. DIGILOW

    2 Pages

  3. Amplifier

    2 Pages

  4. TYP 9250

    6 Pages

  5. Load cells

    25 Pages

  6. Torque Sensors

    9 Pages

  7. Model 8709

    2 Pages

  8. Load cells

    25 Pages

  9. Model 1282

    2 Pages

  10. 1144-Pt

    2 Pages

  11. ForceMaster

    4 Pages

  12. 9243

    2 Pages

  13. DIGIFORCE® –

    9 Pages