For static and dynamic applications, non-rotary Model 8627 Application This torque sensor is qualified for static and dynamic measurements on non-rotary applications. Further the measurement of reaction torques on rotating machine parts is possible. Especially torque sensors with flanges are preferred. They are mounted between motor and stator, e.g. in agitator drives. This enables a maintenance-free torque measurement. For individual measuring tasks the design of our torque sensors can be adapted to the customer’s installation conditions. Measurement range from 0 ... 500 Nm to 0 ... 5000 Nm Simple handling and assembly Output signal standardized Optional linearity error 0.05 % F.S. Optional with burster TEDS Description The design is optimized regarding overall length, weight and volume, so that axial forces up to relatively high limit values and bending moments of up to 20 % of the measuring range have only a small effect to the influence of the measuring element. Four metal film strain gauges are mounted on the measuring element and connected to form a full bridge. When applying AC or DC voltage on the bridge, the mechanical value torque is converted into electrical voltage. The necessary amplifier either delivers a norm signal (0 … 10 V, 0/4 … 20 mA) or – with indicator module – a torque signal truly corresponding to the measured variable. The sensor output signal is standardized, so that an exchange of the sensor (spare part) does not require any new adjustment of the measuring chain. The burster TEDS option (electronic data sheet, memory chip with sensor-specific data) allows rapid configuration of compatible evaluation units (instrumentation amplifier, indicator, ...). Technical changes reserved. All data sheets at www.burster.com burster praezisionsmesstechnik gmbh & co kg Germany www.burster.com Talstr. 1-5 . Gernsbach 76593 . Phone +49-7224-6450 [email protected]

Technical Data Order Code Measuring Range Bore Holes Higher measuring ranges upon request. Electrical values Dimension drawing model 8627 Resistor bridge (full bridge): foil strain gauge 350 Ω, nominal* * Deviation from the indicated values are possible. Excitation voltage: 2 ... 12 V recommended 10 V Nominal value: standard, 1 mV/V Measuring side Environmental conditions Operating temperature range: - 15 °C ... + 55 °C Rated temperature range: - 5 °C ... + 45 °C Temperature effect: on zero signal: ± 0.02 % F.S./K on characteristic value: ± 0.01 % F.S./K 6 pins connecting plug Mechanical values...