Catalogs >
burster präzisionsmesstechnik gmbh & co kg >
Data Sheet Models 8712, 8713

Data Sheet Models 8712, 8713
2Pages

Catalog excerpts

Potentiometric Sensors Models 8712, 8713 Displacement Code: 8712 EN Application These displacement sensors are potentiometric displacement sensors used for direct measurement, testing and monitoring of mechanical displacements. The spring-loaded control rod eliminates the need of coupling with the measurement object. A prerequisite for a very long life duration of the devices is a parallel alignment of the motion direction of the measurement object and the rod. Areas of application are: Displacement on ► Electromagnets ► Hydraulic cylinders ► Switches and buttons Measurements of ► Deformation ► Bending ► Press-fits ► Feed strokes Measurement ranges: 0 ... 10 mm to 0 ... 150 mm Non-linearity from 0.05 % F.S. Durability 108 operations Resolution 0.01 mm Follower roll on request Optional with internal spring Description Due to the technology employed in potentiometric displacement sensors, they always operate with a sliding contact system. Special processes are applied to give the resistance tracks low friction, low tendency to stick/slip, resistance to abrasion and a long-term stability. The rods are guided in long-life, low friction sliding bearings with close tolerances which provide high durability and measuring quality. The pre-stressed spring presses the sensor tip against the measurement object. This spring is double-guided and disappears in the probe head, if the rod is in its end position. The probe tip consists of a ball made of stainless steel. The bore at rod end serves for coupling retraction units. The rod is protected against twist for measurement ranges up to 50 mm. The probe tip (hexagonal) must not be turned by any tool, otherwise its anti-twist protection will be destroyed. Technical changes reserved. All data sheets at www.burster.com burster praezisionsmesstechnik gmbh & co kg Germany www.burster.com Talstr. 1-5 Gernsbach 76593 Phone +49-7224-6450 info@burster.com

Open the catalog to page 1

"total mechanical deflection Electrical values Resistance: measuring range 10 mm and 25 mm 1 kQ Max. operating voltage: measuring range 10 mm 14 V Recommended current in slider circuit: < 0.1 pA Max. current in slider circuit: 10 mA (> 0.1 pA negative influence to linearity and durability) Electrical strength: 500 Veff at 50 Hz Environmental conditions Storage temperature range: - 50 °C ... 120 °C Nominal temperature range: - 30 °C ... 100 °C Temperature coefficient: of connection resistance max. - 200 ± 200 ppm/K of output voltage < 1.5 ppm/K Mechanical values Non-linearity: refer to table...

Open the catalog to page 2

Data Sheet Models 8712, 8713 2Pages

Catalog excerpts

All Burster präzisionsmesstechnik gmbh & co kg catalogs and technical brochures

Data Sheet Models 8712, 8713
2Pages