Delivery: ex stock | Warranty: 24 months Miniature Ring Load Cell Highlights ■ Measuring ranges from 0 ... 100 N up to 0 ... 200 kN ■ Continuous centric internal hole measured to fit ■ Flat disc design ■ Completely welded sensor body ■ Internal thread in the bottom for fixing ■ Standardization of the nominal sensitivity ■ Various cable lengths available ■ Customization of geometry possible ■ Force monitoring during riveting ■ Measuring contact forces in hydraulic stamps ■ Monitoring pulling forces during wire production ■ Monitoring of forces in prestressed concrete structure The force to be measured must be introduced axially and perpendicularly to the entire surface of the inner and outer bands of the sensor in the opposite direction. Conversion of the acting force into an electrical output signal is performed by strain gages connected together in a full bridge circuit. To achieve optimal accuracy, the base of the sensor should rest on a smooth level surface, hardened to at least > 58 HRC with sufficient dimensions. The base cover welded to the surface has a stabilizing effect on the sensor element. Lateral forces must be avoided anyway as they distort the measured results. Tension and bending relief for the sensor cable is to be carried out on the machine side. burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

Relative non-linearity* Characteristic curve deviation* Relative hyst eresis Temperature effect on zero output Temperature effect on nominal sensitivity Electrical value Sensitivity nominal Measurement direction Bridge resistance Insulation resistance compression direction. Calibration and positive signal in compression direction. realized on board 48 x 7mm (L x B) in the cable after 1.5 m and 1.7 m from the sensor resp. 0.3 m from cable end (±0.25 %) Environmental conditions Nominal temperature range Operating temperature range Mechanical values Deflection full scale Maximum operating force...

Requirements for evenness of the mounting surfaces: 5 pm, Parallelism of the mounting surfaces: 20 pm. Surface hardness: > 58 HRC. Mounting instructions Mounting: measuring range > 0 ... 1000 N There are three mounting holes on the lower side of the sensor, equally spaced on T diameter with division 120°, one hole is located directly across the cable exit. This kind of mounting is allowed for compression load only burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

burster load cells are based on a strain-gage Wheatstone bridge. This measurement principle means that the output voltage mV/V is highly dependent on the sensor supply voltage. Our website contains details of suitable instrumentation amplifiers, indicator and display devices and process instruments. The "burster Transducer Electronic Data Sheet" (TEDS) is a memory in which identification data of the sensor, calibration data and other sensor parameters are saved. In conjunction with your own suitable burster device, there is the option of performing a simple adjustment in order to achieve the...

burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

Measuring range Nominal sensitivity/not standardized Connection cable 1.7 m (with standardization in the cable 2 m) Connection cable 3 m Connection cable 5 m Connection cable 3 m, extended * Connection cable 5 m extended * (with sens line ‘ shortened delivery time compared with cable length 3 m and 5 m in one piece ■ Non-linearity according to specification ■ Brochure Our brochure „Load cells for production, automation, R&D and quality assurance" is available for download on our website. It conatains numerous applications, detailed product specifications and overviews. ■ Product videos Watch...