Delivery: ex stock | Warranty: 24 months Strain gage simulator / Sensor test / Precision voltage source Highlights ■ Precision measuring chain ■ Portable data-logger for up to 30.000 measured values ■ Ultra-low non-linearity of less than 0.001 % F.S. ■ Up to 16 measuring programs can be configured and saved ■ Easy sensor configuration by burster TEDS ■ Wheatstone full bridge simulator ■ High-precision voltage source 0 to 10 V DC ■ DAkkS/factory calibration certificate available for the device or the entire measuring chain (optional) ■ High-precision system calibrations of presses and assembly lines ■ Checking and readjusting presses, production systems and testing machines ■ Strain gage sensors The TRANS CAL 7281 can be fitted with standard or rechargeable batteries for portable use or can run from an external power supply for stationary use for a longer period of time. In conjunction with a sensor, the device can be used flexibly as a reference measuring chain, e.g. for force, torque and pressure measurement, and is particularly suitable for service technicians for calibrating and, if necessary, adjusting different systems. The choice of sensors includes strain gage, normalized signal ±5 V/ ±10 V and potentiometric sensors. The graphical LCD display shows the current measured value. The bar display below shows the level of the measuring range. In addition, information about the percentage of the electrical input voltage range used is also shown. It also supports display functions such as data-logger, tared value in percent and upper/lower limit for the comparator with simultaneous indicator (> = <) of the evaluation result. With the extended sensor test and strain gage simulator functions and the precision voltage source, you have the most important tools for regularly checking your complete system and quickly localizing faults and calibrating instrumentation amplifiers. DAkkS calibration certificates/factory calibration certificates are optionally available. The TRANS CAL configuration and data-collection software provides useful display and reporting functions. burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burst

Technical data Reference tester operating mode burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

D-SUB 9-pin connector (device test and strain gage simulator) Pin burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

Application Basic version 7281-V0010High-precision calibration/reference measuring chain: The multipurpose TRANS CAL 7281 digital indicator can be used wherever there is a need to perform high-precision, in-situ measurement and calibration of sensing components used in equipment such as presses, torque tools and pressure-regulating systems. With a DAkkS or factory calibration certificate for the entire measuring chain, the data-logger is ideal for use as a mobile or stationary reference. This enables you to evaluate your system quickly, regularly and cost effectively at any time and to document...

Calibration of the measuring chainCalibration 72ABG Calibration of the 7281 display unit with standard sensors (inc. ABG calib. report) 72ABG-2 (for TEDS) Calibration of the 7281 display unit with TEDS sensors (inc. ABG calib. report) Calibration certificate with accreditation symbol Calibration certificate with accreditation symbol for the TRANS CAL 7281. Calibration is based on the accreditation of calibration laboratory D-K-15141-01-00 for the scope of parameters listed in the annex of the accreditation certificate. Traceability to national standards and wide international recognition is therefore...