Delivery: ex stock | Warranty: 24 months burster Measuring Amplifier for Strain Gage Sensors NEW Pluggable variant on the output side via M12 5-pin connector Highlights ■ Operates with up to 4 measuring channels ■ Protected against reverse connection and short-circuit ■ Also available as circuit board without housing ■ Simple configuration using DIP switch ■ High degree of protection up to IP67 Options ■ Inline version with PG screw connection (Standard) ■ Inline version with M12 5-pin connector on the output side ■ Circuit board version ■ Hat rail version in multi-channel housing with 2, 3 or 4 measuring channels Applications ■ Automatic production machinery ■ Integration into customer's circuit boards IP67 version Circuit board version Product description The input range of the cost-effective amplifier is appropriate for sensitivities between 0.5 and 30 mV/V and is also suitable for semiconductor strain gage. The measuring amplifier itself is powered by voltages between 15 V and 30 V. Internally, the highly accurate, short-circuit protected sensor excitation voltage is generated and used to supply the sensor's measuring bridge. The analog output voltage can be set to a range from 0 to ±5 V or 0 to ±10 V. Alternatively, customer-specific settings are possible. DIP switches are used to set the input range. Fine adjustments and zero point setting are performed by means of multi-turn potentiometers that are mounted on the circuit board. The sensors are connected, and the auxiliary power supplied, through user-friendly screw terminals. The amplifier in the IP67 version can, if in fact necessary, be achieved by clamping, gluing, or with the aid of a cable tie. The open circuit board has mounting holes for easy assembly. The amplifier's limit frequency is 1 kHz. Various housing variants are available. For field use, the IP67 variant with PG screw connection or, alternatively, with an M12 connector on the output side is available. The pluggable version allows for quick and easy installation and removal. Since the sensor is permanently connected to the measuring amplifier, the measuring chain can be installed as a whole. For mounting the measuring amplifier in the control cabinet, we recommend the 2-channel, 3-channel, or 4-channel DIN rail version. For use in the laboratory or as an OEM product, the pure circuit board version can be selected. burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

Terminal assignment Circuit board and version in tube housing Mounting rail version, 2 channel SENSOR side left Zero point shield = hole = pipe housing ^ GND mounting rail version, 3 or 4 channel top burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

Standard factory calibration certificate for measurement chains (WKS) burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

Order number 8526-6001-S000S000 Compression load cell model 8526, measuring range 1 kN, characteristic value standardized to 1.0 mV/V 9236-V001 Model 9236 instrumentation amplifier, pluggable on the output side using an M12 connector 92ABG Calibration of measuring chain 9900-K303 Connection cable with M12 connector, length 3m burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com