Delivery: ex stock | Warranty: 24 months Bending Beam Tension and Compression Load Cell MODEL 8511 Highlights easuring ranges from 0 ... 5 N up to 0 ... 2 kN, M 0 ... 1.1 lbs up to 0 ... 449.6 lbs Easy installation High linearity Special design upon request Options Non-linearity up to ±0,03 % F.S. Standardized nominal sensitivity burster TEDS Applications Dosing system Tension force measurement for wire or thread winders Cable force Review of pull-off forces Product description Measuring direction Easy installation The measuring element of the load cell consists of a double bending beam on which strain gages are applied. The applied force detunes the measuring bridge so that a proportional output voltage is generated. The strain gages on the measuring element are protected against dirt and water spray by a rubber bellows. The sensor can be easily mounted via two mounting holes. The tension or compression force to be measured is introduced at the opposite end perpendicular to the sensor axis. Due to its special design, the influence by an extension (e.g. touch finger) on the measuring signal is low. Overload protection can be realized with little effort using a mechanical stop. burster Sensors and Process Instruments – Technical changes reserved. All data sheets at www.burster.com

Measuring range calibrated in N from 0 ... Accuracy Relative non-linearity* Relative non-linearity* Characteristic curve deviation* Relative hysteresis Temperature effect on zero output Temperature effect on nominal sensitivity Electrical values Sensitivity nominal Tension and compression direction. Load calibration in compression direction (clearly marked by an arrow on the sensor). The full-scale output is likely to be different when used in the tension direction. Positive signal in compression direction. Measurement direction Standardization** Bridge resistance 350 Ω nominal (deviations are...

Dimensional drawing Measuring range from 0 ... General tolerance of dimension burster Sensors and Process Instruments – Technical changes reserved. All data sheets at w

Electrical termination Output signal burster load cells are based on a strain-gage Wheatstone bridge. This measurement principle means that the output voltage mV/V is highly dependent on the sensor supply voltage. Our website contains details of suitable instrumentation amplifiers, indicator and display devices and process instruments. Excitation + (white) Output signal - (green) burster burster TEDS The "burster Transducer Electronic Data Sheet" (TEDS) is a memory in which identification data of the sensor, calibration data and other sensor parameters are saved. In conjunction with your own...

Calibration Test and calibration certificate Supplied with the sensor Amongst other data, includes figures for zero point, full-scale output and calibration offset Standard factory calibration certificate for load cells or measurement chains (WKS) Optionally available Our standard factory calibration is performed in 20% steps starting from zero until the reaching the nominal force, for increasing and decreasing load with unchanged installation position. Factory calibration can be performed in compression and/or tension direction. Special factory calibration certificate for load cells or measurement...

Order Code Measuring range 0 ... Delivery ex stock at short notice N 8 Nominal sensitivity/not standardized *** temperature range for the optional TEDS or standardization board 0 ... 60 °C Connection cable 1.7 m (Standardization 2 m) Connection cable 3 m extended * Connection cable 5 m extended * (with sens line) * shortened delivery time compared with cable length 3 m and 5 m in one piece Open cable ends + 6 cm single wires 9 pins Sub-D connector model 9900-V209 9 pins Sub-D connector model 9900-V209 for 9163-V3xxxx 12 pins round connector model 9941 for burster desktop devices 9 pins Sub-D...