Delivery: ex stock | Warranty: 24 months Bending Beam Tension and Compression Load Cell ■ Measuring ranges from 0 ... 5 N up to 0 ... 2 kN, ■ Special design upon request ■ Standardized nominal sensitivity ■ Tension force measurement for wire or thread winders ■ Review of pull-off forces The measuring element of the load cell consists of a double bending beam on which strain gages are applied. The applied force detunes the measuring bridge so that a proportional output voltage is generated. The strain gages on the measuring element are protected against dirt and water spray by a rubber bellows. The sensor can be easily mounted via two mounting holes. The tension or compression force to be measured is introduced at the opposite end perpendicular to the sensor axis. Due to its special design, the influence by an extension (e.g. touch finger) on the measuring signal is low. Overload protection can be realized with little effort using a mechanical stop. burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

Relative non-linearity* Relative non-linearity* Characteristic curve deviation* Relative hyst eresis Temperature effect on zero output Temperature effect on nominal sensitivity Electrical values Sensitivity nominal Measurement direction Standardization** Bridge resistance Excitation Insulation resistance Tension and compression direction. Load calibration in compression direction (clearly marked by an arrow on the sensor). The full-scale output is likely to be different when used in the tension direction. Positive signal 350 Q nominal (deviations are possible) Environmental conditions Nominal...

burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

burster load cells are based on a strain-gage Wheatstone bridge. This measurement principle means that the output voltage mV/V is highly dependent on the sensor supply voltage. Our website contains details of suitable instrumentation amplifiers, indicator and display devices and process instruments. The "burster Transducer Electronic Data Sheet" (TEDS) is a memory in which identification data of the sensor, calibration data and other sensor parameters are saved. In conjunction with your own suitable burster device, there is the option of performing a simple adjustment in order to achieve the...

burster Sensors and Process Instruments - Technical changes reserved. All data sheets at www.burster.com

Order Code Measuring range 0 ... Delivery ex stock at short notice N 8 Nominal sensitivity/not standardized *** temperature range for the optional TEDS or standardization board 0 ... 60 °C Connection cable 1.7 m (Standardization 2 m) Connection cable 3 m extended * Connection cable 5 m extended * (with sens line) * shortened delivery time compared with cable length 3 m and 5 m in one piece Open cable ends + 6 cm single wires 9 pins Sub-D connector model 9900-V209 9 pins Sub-D connector model 9900-V209 for 9163-V3xxxx 12 pins round connector model 9941 for burster desktop devices 9 pins Sub-D...