DIGILOW Digital indicator for strain gauge sensors Model 9186 Code: 9186 EN Desktop version ■ Less expensive digital display ■ For force, pressure or torque measurements using gauge sensors ■ Two limit alarms optionally available ■ Extremely easy-to-read display with 20 mm digit height ■ Display range -1999 to + 9999 ■ TARE function ■ Scaling possible using teach-in procedure or by entering sensor data directly Application The DIGILOW digital display can be used with strain gauge sensors measuring force, pressure or torque. The range of functions has been limited deliberately to ensure operation is simple and self-explanatory. With its unique, large and clear digit height of 20 mm, the digital display can be installed easily in process control panels and control cabinets. Thanks to the large choice of measurement signals that can be indicated, the display is ideal for use in a huge range of industry-based applications. As a simple and compact digital display, it can also be used as a multi-channel solution in laboratory or test systems, where several different measurements may need to be taken and displayed simultaneously. The front panel TARE function for the strain gauge sensor input makes it easy to zero the display for processes where an initial load may be applied (containers’ own weight, pre-tensioning of sensor by tool adaptation and so on). Production-oriented evaluation and control functions can be implemented using the limit generation option. Description The production of this excellent value digital display was possible by employing state-of-the-art microprocessor technology and keeping the complexity of the internal design to a minimum. The simple menu-driven instrument setup procedure with self-explanatory mnemonics ensures that even the novice can use the unit immediately without an operating manual. First, the user specifies the type of input signal or sensor. Then the user can select the relevant calibration procedure by either applying an input meas-surement or through teach-in (calibration taken from sensor documentation). The position of the decimal point can be set to suit, while the sensor supply voltage can be hardware-set to 5 VDC (default) or 10 VDC. There is also the option to use a digital low-pass filter to correct any display flicker caused by the particular application. Technical changes reserved. All data sheets at www.burster.com burster praezisionsmesstechnik gmbh & co kg Germany www.burster.com Talstr. 1-5 Gernsbach 76593 Phone +49-7224-6450 [email protected]

16 bit 0.1 % v. E. ± 4 digits 100 ppm/K 10 minutes - 1999 ... + 9999, height 20 mm 250 ms 25/sec. - 10 ... + 60 °C 95 % at 40 °C Front panel IP65 96 x 48 x 60 [mm] approx. 90 mm 92 x 44 [mm] 250 g plastic 130 x 70 x 150 [mm] 250 g Plastic Technical Data Connectable sensors Strain gauge Connection system: 4 wire Bridge voltage: 30 mV / 300 mV / selection via menu Standard functions TARE Balancing-out an offset Digital control input TARE General specifications Accuracy Resolution: Measurement error: Temperature coefficient: Warm-up period: Display Display: Display timing: Measurement range Environmental...