Water alarm WW 6 series
2Pages

{{requestButtons}}

Catalog excerpts

Water alarm WW 6 series - 1

The entrance of water into fluid power or lubrication systems reduces the life of oil significantly and causes damage to other components used in the systems. The most reliable method of detecting water in oil is to measure the interface level between water and oil when the water is separated. The BUHLER water alarm units have a float which rises in water but sinks in oil. It only takes a build- up of around 90 ml of water in the sight glass to elevate the float and actuate a contact to signal danger. Water alarm units for intank installation as well as with two switching points and higher maximum pressure are available upon request. ■ Reliable physical measuring system Buhler Technologies GmbH Internet: www.buehler-technologies.com e-mail: fluidcontrol@buehler-technologies.com

Open the catalog to page 1
Water alarm WW 6 series - 2

Technical Data Operating temperature Protection class Cable gland *NO=normally open NO*- or change over- contact Wiring Diagram one contact NO (normally open) one change over contact All figures at empty reservoir (float on bottom). The assembly kit enables a compact and easy installation of the water alarm unit to connections, fittings and shut off valves. The fittings provide a very small "dead" volume. The upper connection is a flexible hose, thus providing a very simple installation. Order Information Part-no. Description 3003999 Water alarm unit WW6, one contact NO 3016999 Water alarm...

Open the catalog to page 2

All Bühler Technologies catalogs and technical brochures

  1. Controllers

    2 Pages

  2. GAS 222.20

    2 Pages

  3. NV 71

    6 Pages

  4. NT 67 XP

    3 Pages

  5. NT 61

    9 Pages

  6. NT M

    4 Pages

  7. SM series

    2 Pages

  8. P 1.1

    3 Pages

  9. AHF

    2 Pages

  10. BF 2-S

    2 Pages

  11. AGF

    2 Pages