Catalogs >
Budenberg >
DX Digital Test Gauge

DX Digital Test Gauge
2Pages

Catalog excerpts

DIGITAL TEST GAUGE The all new DX digital gauge from Budenberg is designed to offer a truly simple, cost effective digital gauge to cover a wide range of applications from calibration laboratory to in-field use. The DX is offered in a choice of standard ranges up to 700 bar in conformance with the EN-837 standard. Alternatively units can be factory programmed to offer the precise range and pressure units required for any particular application. Based around a high specification Peizoresistive silicon sensor, the DX has an accuracy of 0.1 % of the calibrated span which is fully temperature compensated across the range of -10 to 50 Deg C thereby allowing accurate readings to be taken over a wide range of ambient conditions. The unit has a large five digit LCD display that incorporates a vertical bar graph to indicate the %age of the range being displayed. Menu keys allow the user to define or reconfigure the mode and characteristics of operation if required. Dial Size 1/4" NPT or BSP male connection in 316 stainless steel. An integral filter in the inlet prevents the ingress of solids whilst an in-built oil filled isolation seal protects the sensor. All liquids and gases compatible with 316 Stainless Steel Scale Ranges Ranges from Vacuum to 700 bar can be provided in either standard ranges as defined in EN-837 or specially programmed to suit the requirement. (Please see overleaf). Pressure Scales psig, bar, mbar, kPa, Mpa, mmHg, "H20, "Hg, mmH20, mH20, Kg/cm2. Two active pressure units can be pre-programmed at the factory or user selectable via the menu keys. 0.1 % of calibrated span on all pressure scales and units 0.25% of vacuum range of-14.5 to 0 psig All units may be safely used to measure vacuum, but only units with a calibrated range of 0-7 bar or less will be rated and tested for vacuum operation Over Scale Range The DXwill read up to 10% above the selected primary pressure Overpressure capability -1 to +7 bar ranges then max overpressure is 21 bar 7 to 70 bar ranges then max overpressure is 140 bar 70 to 0-700 bar ranges then max overpressure is 1400 bar Large five full seven-segment LCD digits, digit height = 0.66" Internal resolution always exceeds the displayed resolution Display rate - 4 readings per second Vertical Bar Chart to show %age of scale Function Keys Front Panel Keys for on/off Menu entry and function set up facility Backlight on/off Unit can be set to display maximum, minimum or average values Battery: Two AA size (RS6) batteries Battery life: (alkaline) > 600 hours typical (backlight off) 50 hours typical (backlight on) Low battery Indicator: Battery icon displayed in LCD screen Sealed to IP66 (NEMA 4) standard Very robust Polyester / Polycarbonate blend

Open the catalog to page 1

Any range up to 700 bar in a choice of single or dual pressure units can be supplied Full Scale Ranges Model, range, overscale, overpressure and resolution Hard Carrying Case for DX Carrying Case for Calibration Kit Specifications and dimensions in this leaflet are subject to change without prior notice.

Open the catalog to page 2