WING NUTS
4Pages

{{requestButtons}}

Catalog excerpts

WING NUTS - 1

» Radiuses as per DIN 315, ergonomically Formed, no sharp edges » Complete range M4 - M24 available while stocks last » On request: specialist threads, specialist parts on the basis of DIN 315 e.g. with eye » RoHS-compliant galvanisation (chromium VI - free) » See also “Specialist wing nuts" PACKAGING: MATERIAL: TOLERANCE: Standard or according to customer specification Malleable cast iron EN-GJMB-350-10 as per DIN EN 1562 bright, galvanised as per DIN EN ISO 4042, brass (MS) 2.0401 as per DIN CEN/TS 13388 bright, nickel-plated as per DIN EN ISO 4042, aluminium (AL); stainless steel A2, A4, pickled, passivated Metric thread 6 H (bright 6 G) as per DIN EN ISO 965-1 All of the dimensions stated above are approximate and may deviate both upwards and downwards.

Open the catalog to page 1
WING NUTS - 2

METRIC ZOLL » Metric thread From M3 to M20 available while stocks last » On request: inch thread, specialist parts on the basis of the American form, e.g. with eye PACKAGING: MATERIAL: TOLERANCE: Standard or according to customer specification Steel bright, galvanised, nickel-plated as per DIN EN ISO 4042, brass bright, nickel-plated as per DIN EN ISO 4042 stainless steel A2 or A4, pickled, passivated Metric thread 7 H (bright 7 G) as per DIN EN ISO 965-1 All of the dimensions stated above are approximate and may deviate both upwards and downwards.

Open the catalog to page 2
WING NUTS - 3

Water wing nuts cast design M8, M10, M12 Surface finish bright or nickel-plated Wing nuts with only one wing cast design M8 Surface finish bright or nickel-plated Scythe nuts cast design M10 » According to BTS company standard » As complete specialist part as per drawing / sample » On request: complete planning and design of new parts STANDARD FINISHES: Bright, galvanised, nickel-plated as per DIN EN ISO 4042 Further materials, finishes and specialist packaging on request.

Open the catalog to page 3
WING NUTS - 4

Modell „S“ - 40 mm wing breadth M5 or M6 Surface finish as requested Modell „SO “ - 60 mm wing breadth M5, M6 or M8 Surface finish as requested Hex wing nuts M6 / spanner width 11 mm M6, M8 or M10 / spanner width 13 mm Thread cast in one piece from wing to hexagon Surface finish as requested Steel sheet wing nuts, galvanised Steel sheet wing nuts, galvanised High form M5, M6 or M8 » According to BTS company standard » As complete specialist part as per drawing / sample » On request: complete planning and design of new parts Minimum volumes are required, depending on article or surface finish.

Open the catalog to page 4

All BTS Befestigungselemente-Technik GmbH catalogs and technical brochures

  1. PURLIN CLIPS

    1 Pages

  2. WING NUTS

    4 Pages

  3. CHANNEL NUTS

    3 Pages

  4. THUMB SCREWS

    2 Pages

  5. BEAM CLAMPS

    4 Pages

  6. WING SCREWS

    4 Pages