BEAM CLAMPS For securing to beams without drilling or welding for: sprinkler systems, heating, ventilation and air-conditioning systems, acoustics systems, electrical, piping and sanitation fittings, engineering and steel structures. The raised marking serves as anti-twist protection when tightening the retaining screw and is protected by internationally registered design DM/0081575! ABC (approx. mm) (approx. mm) (approx. mm) D E F G H Weight Rated load Certificates (approx. mm) (approx. mm) (approx. mm) (approx. mm) (approx. g) (N) » Where possible, VdS, FM and UL certified » Full range for M6 - M16 threaded rods from stock » Inch thread on request » Clamping widths from 18 - 45 mm » Please also note “Product benefits" information sheet PACKAGING: MATERIAL: SCOPE OF SUPPLY: SURFACE FINISH: 50 pcs in box or according to customer specification Malleable cast iron body, general tolerances as per DIN EN ISO 8062-3 CT8 Mounted with DIN 933 8.8 hex bolt, end with cup point (CP) as per EN ISO 4753 and DIN 439 lock nut Galvanised as per DIN EN ISO 4042, on request hot-dip galvanised as per DIN EN ISO 1461, or also coated with zinc flake (e.g. Geomet) All of the dimensions stated above are approximate and may deviate both upwards and downwards.

For securing to beams in the Following areas: sprinkler systems, heating, ventilation and air-conditioning systems, acoustics systems, electrical, piping and sanitation fittings, engineering and steel structures. Rated load [N] For threaded rods » With DIN 933 M10x40 retaining screw with cup point [CP] and DIN 439 hex nut » Marking “9mm", “11mm" or “13mm" and material MATERIAL: Stainless steel A2 (1.4301) or A4 (1.4401) SCOPE OF SUPPLY: Mounted with DIN 933 hex bolt, end with cup point (CP) as per EN ISO 4753 and DIN 439 lock nut All of the dimensions stated above are approximate and may deviate...

Product benefits of certified beam clamps: » Enable use in certified fixed sprinkler systems » Load values assured by independent institutes » Cup point end to prevent sideways movement from the T-beam » In the case of beam clamps with through bores a simple height adjustment can also be undertaken following mounting » Pre-assembly with threaded rod and lock nut possible Further product benefits of BTS beam clamps: » Malleable cast iron body, made in Germany » Prior to processing, inspection of all cast parts for visible bubbles » Retaining screws and lock nuts of all beam clamps can be tightened...

Our type TK and TKN beam clamps can be mounted with the tensile direction against the retaining screw or against the support. Please see our mounting instructions for further information. The use of securing straps for beam clamps is compulsory for > DN65 pipes under VDS regulations. All beam clamps can be secured with a securing strap against sideways slipping from the beam. Responsible authority regulations are to be observed. MATERIAL: Steel SURFACE FINISH: galvanised as per DIN EN ISO 4042 All of the dimensions stated above are approximate and may deviate both upwards and downwards.