Catalogs >
Brevini Power Transmission >
Data sheet series 390 Maximum bearing life

Data sheet series 390 Maximum bearing life
2Pages

Catalog excerpts

Data sheet series 390 Maximum bearing life - 1

0.01 with length compensation, tubular design 0.02 with large length compensation, tubular design 0.03 without length compensation, tubular design 9.01 with length compensation, short design 9.02 with length compensation, short design 9.03 with length compensation, short design 9.04 without length compensation, double flange shaft design © Spicer Gelenkwellenbau GmbH If the permissible functional limit torque Tcs is to be fully utilized, the flange connection (e.g., with dowel pins) must be reinforced. Yield torque 30% over Tcs T dw = Reversing fatigue torque* Lc = Bearing capacity factor* * See specifications of driveshafts. b = Maximum deflection angle per joint 1) Effective spigot depth 2) Number of flange holes (standard flange connection) 3) Number of flange holes (dowel pin connection) 4) 390.60 - 390.70 + 0,2 mm 390.75 - 390.80 + 0,5 mm

Open the catalog to page 1

Data sheet series 390 Maximum bearing life - 2

Standard flange connection Dowel pin connection according to DIN 15451 NOTE: Each driveshaft size has a specific hole pattern (see table). Other hole patterns available on request. C = Torsional stiffness of shaft without tube Cr = Torsional stiffness per 1.000 mm tube * Larger length compensation available on request Lz min = Shortest possible compressed length La = Length compensation Lf min = Shortest fixed length Lz + La = Maximum operating length Gr = Weight per 1.000 mm tube Jm = Moment of inertia JmR = Moment of inertia per 1.000 mm tube © Spicer Gelenkwellenbau GmbH

Open the catalog to page 2