2H MASSdek 250 HTC Performance Data
2Pages

Add to favorites

{{requestButtons}}

Catalog excerpts

2H MASSdek® 250 HTC PERFORMANCE CHARACTERISTICS Structured packings for scrubbers and strippers 2H MASSdek® 250 HTC For clean media and minor dirt load extremely low pressure drop Important Information The given data illustrates the ideal characteristics of mass transfer performance and pressure drop of our structured packing. The data has been collected from a test tower and is only valid for uniform air and water distribution before and after the packing. The optimum performance is only reached after a sufficient wetting period of 2-3 months. The performance of the process not only depends on the performance of the structured packing but also significantly on the boundary conditions of the tower, the effects of initial liquid and gas distribution, mixture and concentrations of multi component liquid and gaseous media and others more. Using these data the designer should add a sufficient safety margin on his basic design. The actual mass transfer performance can deviate significantly from the ideal characteristic data of the structured packing mentioned within this data sheet. We do not take any responsibility for any calculation to establish the size of tower with our data no matter the scope or cause in law. We reserve the right to amend data without prior notice.

Open the catalog to page 1

Technical Data Technical Data PP/PVC Void ratio Specific surface area Channel inclination Standard height Continuous application temperature Layer height *2H MASSdek is produced from special PP compounds. For temperatures above 70 °C and exposure to chemicals we apply special additives or we recommend PVDF. Please contact us for our recommendation. Pressure Drop Pressure Drop Δp/H [inch H2O/ft] System: air/water Pressure drop of dry packed bed ∆p0/H and of irrigated packed bed Δp/H as a function of gas capacity factor FV and at different specific liquid loads uL valid for plastic packing,...

Open the catalog to page 2

All Brentwood Europe GmbH catalogs and technical brochures

1. 

   Biological Exhaust Treatment (Odor Control)

   8 Pages

2. 

   Sedimentation Technology

   20 Pages

3. 

   2H BIOdek IFAS (integrated fixed film activated sludge) - Solution to upgrade/extend activated sludge plants

   2 Pages

4. 

   2H BIOdek© FAP Tubular Design Fills

   2 Pages

5. 

   2H SKR Sedimentation Tank Unit

   4 Pages

6. 

   2H Drift Eliminators

   2 Pages

7. 

   2H Splash/Trickle Fills

   2 Pages

8. 

   2H HUMIPACKING

   2 Pages

9. 

   ENEXIO - 2H components for stromwater infiltration

   4 Pages

10. 

    ENEXIO - 2H Components for Trickling Filters

    4 Pages

11. 

    2H BIOdek IFAS System & Components

    2 Pages

12. 

    ENEXIO - 2H Components for Mass Transfer

    16 Pages

13. 

    ENEXIO Installations for Mass Transfer

    48 Pages

14. 

    2H MASSdek 150 HTC Performance Data

    2 Pages

15. 

    2H MASSdek 125 HTC Performance Data

    2 Pages

16. 

    2H MASSdek 80 GRID Performance Data

    2 Pages

17. 

    2H MASSdek 250 HTE Performance Data

    2 Pages

18. 

    Fill media for Agricultural Engineering

    4 Pages

19. 

    2H AGRIdek Climate System

    4 Pages

20. 

    2H AGRIdek Dedust Packings

    2 Pages

21. 

    2H TUBEdek Tube Settlers (Lamellas)

    2 Pages

22. 

    2H BIOdek Vertical Flow Fills

    2 Pages

23. 

    2H BIOdek Cross-Fluted Fills

    2 Pages