The Branson SW200 is a precision servo-driven spin welding system capable of welding circular parts with accurate control. It is easy to set up and operate. The SW200 is designed for use in manual, semi-automated, or fully- automated environments.A free-standing operator interface allows forthe following adjustments: revolutions per minute (RPM), revolutions per cycle (RPC), and hold time (HT). ? Adjustable RPC (revolutions per weldcycle). This provides for consistent weld results. ? Rapid deceleration provides high-strengthbonds. ? Adjustable hold time ? Adjustable height (18"/457 mm) andstroke (up to 3.5"/89 mm) provide ease of setup. > 41 Eagle RoadDanbury, CT 06813-1961(203) 796-0349 Fax(203) 796-9838Email: [email protected] ? Servo drive provides final part orientationto within 1 ? Dual non-tie-down palm buttons withemergency stop to ensure safe operation. > o . ? Precise RPM control maintains constantvelocity. ? Ergonomic base >

Weight: Maximum force Stand:275 lbs. (125 kg)Operator Interface:65 lbs. (30 kg) applied to part:314 lbs. ( 1.4 kN ) Pneumaticrequirement: Stroke length: 3.5" (89 mm) Clean (5 micron),dry air, 100 psi max.; 1 CFM Height adjustment: 18" (457 mm) Mounting hole pattern: Throat (tooling center-line to column):10.625" (270 mm) 3/8-16 tapped holes on center, and on 4-7/16", 7", and 9" bolt circles Drive tool to basedistance :2" to 20" (51 to 508mm) Dimensions: > Power requirement: 220-240 V AC, 20 amps, 3-phase, 50/60 Hz Note: All specifications subject to change withoutnotice. > 2"-20"" 16.37" 27.78"...