2032S - 2 Pages

Add to MyDirectIndustry favorites
2032S

Catalog excerpts

BRAIMSON Ultrasonic WeldingUltrasonic Splicing System The 2032S is a full-range ergonomic wire splicing system to produce high-quality splices at the lowest cost operation. actuator at the workstation in under two minutes for off-line maintenance and maximum production. For application requirements demanding a full-range ultrasonic splicing system, Branson offers the Ultrasplice® system, capable of splicing from 0.7 to 40mm2 (for 4.0 kW) CSA (cross sectional area). The system utilizes a retractable anvil and will automatically sequence to produce the full range of splices required. All critical splice parameters are monitored to ensure the highest quality splice. The ultrasonic horn and actuator housing design provides the operator with optimum ergonomic conditions allowing for ease of use. Features The units are easy to maintain and access: • Special 'keyed connector' (single point) air and electrical disconnect permit instant replacement of a production • Critical tooling clearances and alignment do not change with use. Automatic Parameter Change Production of a wide range of splices as found on a harness board or in today's 'just-in-time' manufacturing require equipment to automatically adjust. The 2032S automatically and instantly adjusts splice parameters, including splice width, pressure, amplitude, and energy. Other Features • Precise, programmable adjustment of splice width • Electronic pressure regulator to accurately control splice force • Electronic amplitude control for precise one-micron adjustment • Quality limits stored in system memory for instant recall and automatic setup EMERSON.Industrial Automation

 Open the catalog to page 1

• Programmable sequencing of splices for automatic switching after a preset number for optimum production efficiency Ease of Operation Easy loading and unloading of splices provided by: • Fully-retractable anvil providing maximum wire load area • Retractable gather tool for easy splice removal Production Flexible Design • Bench-top unit • Mount in a workstation table • Use with a barcode wand for instant 'non programmable 'just-in-time' production • Connect to a computer or network Patented Anti-Side Splice Feature One of most common causes for field failures is side splicing (Figure I). If...

 Open the catalog to page 2

All Branson Ultrasonics catalogs and technical brochures

  1. OMNI 2000

    2 Pages

  2. CPN 955-007

    2 Pages

  3. 2000xc

    2 Pages

  4. DHA-1000

    2 Pages

  5. B-3

    2 Pages

  6. B-200

    2 Pages

  7. PC-620

    2 Pages

  8. IC Series

    2 Pages

  9. CPXH Series

    2 Pages

  10. CPX Series

    2 Pages

  11. MH/M Series

    2 Pages

  12. Cup Horn

    2 Pages

  13. Microtips

    2 Pages

  14. DCX A-F

    6 Pages

Archived catalogs