Catalogs >
BRAND HYDRAULICS >
Mono-block directional control w/ auto-cycle hydraulic kick out

Mono-block directional control w/ auto-cycle hydraulic kick out
4Pages

Catalog excerpts

Mono-block directional control w/ auto-cycle hydraulic kick out - 1

ISO 9001:2008 WITH DESIGN Certificate #02.002.1 MONO BLOCK DIRECTIONAL AUTO-CYCLE VALVE “LA” AUTOCYCLE A DOUBLE ACTING CYLINDER with one input from the user. ADJUSTABLE HYDRAULIC KICKOUT on both spools. O’RING PORTS to eliminate leakage. POWER BEYOND CAPABILITY to fit your multi valve circuits. PRECISION GROUND IOSSO PLATED SPOOL that assures long life. 18 gpm (68.0 lpm) Nominal Capacity. Rated up to 2000 psi kickout (138 bar). Port Sizes-Inlet/Outlet #12SAE (1-1/16-12). -Work Ports #10SAE (7/8-14). 10 Micron Filtration Recommended. Weight - 14 lbs. (6.4 kg). Cast Iron Body Buna N O’Rings IOSSO Plated Steel Spools Black Nylon Ball Knob

Open the catalog to page 1

Mono-block directional control w/ auto-cycle hydraulic kick out - 2

Directional Control Valves LA – GENERAL INFORMATION The Brand autocycle valve will cycle a double acting cylinder from retracted to fully extended and then back to fully retracted using two spools. The first spool can be used to manually extend and retract cylinder while the second spool only retracts the cylinder. Pushing both levers forward starts the autocycle process. The first hydraulic detent can be adjusted up to 2000 PSI (103 bar) and the second detent should always be set 500 PSI (34 bar) above the first detent setting. The valve is also field convertible to closed center and power...

Open the catalog to page 2

Mono-block directional control w/ auto-cycle hydraulic kick out - 3

Directional Control Valves LA – COMPLETE LIST OF OPTIONS AND ACCESSORIES: 34R10……………….….. Area differential relief cartridge set at 1000 psi (69.0 bar). (Available in pressure setting increments of 100 psi (6.9 bar), please specify desired setting as per this example) TS-HJ…………………... TS handle kit with ball knob. (One per spool) TS-HJBL………………. TS handle kit double bend, away, offset left with ball knob. (One per spool) TS-HJBR………………. TS handle kit double bend, away, offset right with ball knob. (One per spool TS-HJS…………………. TS straight handle kit with ball knob. (One per spool)...

Open the catalog to page 3

Mono-block directional control w/ auto-cycle hydraulic kick out - 4

Directional Control Valves AUTO-CYCLE HYDRAULIC CIRCUIT: ROD END OF CYLINDER CAP END OF CYLINDER OUTLET TO TANK PORT A2 TO ROD END OF CYLINDER OPTIONAL POWER BEYOND PORT PORT A1 TO CAP END OF CYLINDER SPOOL TWO CAN ONLY RETRACT CYLINDER SPOOL ONE CAN EXTEND AND RETRACT CYLINDER KICKOUT ADJUSTMENTS NOTE: PORT B2 IS PLUGGED ADJUSTABLE RELIEF VALVE (2300 psi (159 bar) STANDARD SETTING) INLET FROM PUMP

Open the catalog to page 4