Catalogs >
BRAND HYDRAULICS >
FC 0-30 gpm (0-114 lpm)

FC 0-30 gpm (0-114 lpm)
4Pages

Catalog excerpts

FULL RANGE PRESSURE COMPENSATING VARIABLE FLOW CONTROL “FC” FC51-3/4 FC51 FCR51-3/4 INLET (IN) FCR51 EXCESS FLOW (EX) DIAMOND HONED SPOOL BORE provides consistent spool fit with low leakage. EVERY FC IS TESTED for shutoff, max. flow, and pressure compensation. STANDARD 3-PORT allows for pressure compensated flow out of two ports. STANDARD 416 STAINLESS STEEL rotary lever spool to prevent the spool from locking up. STANDARD SAE ORB COMPENSATOR PLUGS to eliminate external leakage from the compensator bore. EXTERNAL SEALS ON ROTARY SPOOL prevents contamination from locking up spool. OPTIONAL TOP PORT allows the customer to plumb their pipe directly in line with the inlet. OPTIONAL 2-PORT allows for pressure compensated flow out of one port. OPTIONAL 316 STAINLESS STEEL rotary spool provides highest corrosion resistance. OPTIONAL FREE REVERSE FLOW allows fluid to move from the CF (control flow) and EX (excess flow) port to the inlet. (Single reverse flow is also available) OPTIONAL ADJUSTABLE BALL SPRING RELIEF AND HIGH LIFT BALL SPRING RELIEF CF (control flow) port. See flow chart for capacity. Rated for 3000 psi (207 bar). Weighs 7- ¾ lbs. (3.52 kg). 30-Micron Filtration Recommended. Torque to turn side lever spool. 35 in*lbs with 3000 psi (207 bar) on EX Port. Cast Iron Body. Heat Treated Compensator Spool. Stainless Steel Rotary Spool. Buna N O’Rings (Standard) Heat Treated Free Reverse Check Seat.

Open the catalog to page 1

FC – GENERAL INFORMATION The Brand, full range pressure compensating variable flow control is designed so that the orifice area varies as the lever is rotated. Fluid travels past the variable orifice, through the compensator spool and then out the controlled flow port. Therefore the flow out of the CF port is proportional to the orifice area which can vary from closed to open. The sum of the controlled flow and the excess flow equals the inlet flow and as the controlled flow increases the excess flow decreases. Both outlet flows are pressure compensated with a spool that maintains a...

Open the catalog to page 2

FC FLOW & PRESSURE INFO: Controlled Flow vs. Dial Plate for FC Series Pressure Drop vs. Flow for FC Series Flow (lpm) 120 Dial Plate Number (0-10) Pressure vs. Flow for FCB51 Pressure vs. Flow for FCR51

Open the catalog to page 3

DIMENSIONAL DATA: FCB51 AND FC51 DIMENSIONAL DATA (inches & [millimeters]): (FCB51 SHOWN): 2.30" [58.5] REF. FCR51 AND FC51 DIMENSIONAL DATA (inches & [millimeters]): (FCR51 SHOWN): 0.94" [23.8] REF.

Open the catalog to page 4

FC 0-30 gpm (0-114 lpm) 4Pages

Catalog excerpts

All BRAND HYDRAULICS catalogs and technical brochures

FC 0-30 gpm (0-114 lpm)
4Pages