Catalogs >
BRAND HYDRAULICS >
EC-12-02

EC-12-02
4Pages

Catalog excerpts

ELECTRONIC PANEL MOUNT CONTROL LIGHTWEIGHT IN DESIGN to minimize panel fatigue. SMALL IN SIZE to minimize space requirements. PULSE WIDTH MODULATION OUTPUT to reduce the effects of hysteresis. SHORT CIRCUIT PROTECTION to guard against over current conditions. (When wired to factory SMOOTH RAMP THERMAL OVERLOAD SHUTDOWN to help protect against overheating. Input protection for transients, load dumps, 2-battery jumps, and reverse polarity hook-ups. TERMINAL BLOCK HAS PRINTED NUMBERS AND A HINGE COVER for easy wiring and accidental short circuit prevention. OPTIONAL POWER SWITCH AND FUSE can be installed separate from the control. THE CIRCUIT BOARD IS COATED WITH A SPECIAL CONFORMAL COATING to guard against moisture, dust and other contaminates. ONLY THREE SMALL HOLES are required for mounting to panel. FOUR PREDRILLED HOLES may be used to surface mount to panel. Output Current: 1.5 amp Max. 1.0 amp Nominal. Output Voltage: 12 VDC, regardless of input supply voltage between 12.70-18.00 VDC. Approximate volume required behind panel: 16 in3 All metal parts are stainless steel, anodized aluminum and zinc plated steel to help prevent corrosion. The control knob is a unique thermal plastic rubber that provides a soft grip with a contemporary look.

Open the catalog to page 1

Electronic Controls EC – GENERAL INFORMATION: The Brand, electronic panel mount control is designed to proportionally adjust the Brand EFC-Series valves and other proportional valves that meet the appropriate solenoid specifications. The panel mount control is designed to mount behind a control panel in an industrial setting, behind the dash panel of mobile equipment, or in any other mounting location. The main control knob is used to linearly adjust the current going through the solenoid on the valve. A large knob and a single turn potentiometer with a large degree of rotation gives smooth...

Open the catalog to page 2

EC/EFC - SERIES SCHEMATIC DRAWING: Electronic Controls FLOW CAN ADSO BE RAN TO TANK. CONTROLLED PLOW PRIORITY PORT, PRESSURE COMPENSATED DIMENSIONAL DATA: inches & [millimeters] 2 MOUNTING PADS: 10-32 UNF THREAD /1=GOES TO POSITIVE SIDE OF BATTERY '2=GOES TO NEGATIVE SIDE OF BATTERY (TERMINALS 3 & 4 HAVE NO POLARITY) (MAXIMUM WIRE SIZE IS 12-AWG PER TERMINAL)

Open the catalog to page 3

Electronic Controls

Open the catalog to page 4

EC-12-02 4Pages

Catalog excerpts

All BRAND HYDRAULICS catalogs and technical brochures

EC-12-02
4Pages