Catalogs >
Boreasa Technologies Co., Ltd >
Small blower C60S1

Small blower C60S1
3Pages

Catalog excerpts

E-mail: sales@boreasa.com, URL : www.boreasa.com Miniature Radial Blower: 61.4 x 61.4 x 50.8 mm (2.42 x 2.42 x 2 in) Housing and Impeller materials: Thermoplastics Lead Wire: 250mm (3 x AWG22, 6 x AWG28) Weight: 225 gr. (7.95oz) Operational Temperature: -20 to 50 ºC / -4 to 122 ºF Three Phase Brushless Motor w/ Hall Sensor Connectors: TE CONNECTIVITY (TE), MICRO-MATCH MOW.06P 215083-6 TE CONNECTIVITY (TE), CST-100 II 1375820-3 Standard Motor Internal Temperature Signal Available in 12 V on demand Note: This blower uses a brushless motor and needs a driver to operate Sample working point NOTES: - Performances are dependent on the driver used and the test conditions. The data in this spec. sheet was obtained using Boreasa test chamber at 20°C (±2° C) and sea level, and using a Boreasa D30/5/4Q-E2 driver. It may be different than data measured in other conditions or with other drivers. - Specifications are subject to change without notice. - Boreasa blowers have been designed and are manufactured to meet the medical device industry requirements. However, it is not possible to test blowers in all conceivable customer application configurations. Consequently, to be used in life support equipment, blowers must be life tested and validated by customers, in their actual application conditions, in a statistically meaningful quantity.

Open the catalog to page 1

E-mail: sales@boreasa.com, URL : www.boreasa.com Technical Data C60S1-24PR-01 L3 VCC Nominal Voltage IN work. point @Nom. Volt. PN work. point @Nom. Volt. n work. point @Nom. Volt. V work. point @Nom. Volt. P work. point @Nom. Volt. Depend on working point Leads Connector TE CONNECTIVITY, Micro-Match MOW.06P 215083-6 TE CONNECTIVITY, CST-100 II 1375820-3 Housing / Impeller Material Ball Bearing Internal Temperature Sensor Note: - Working point is an example close to 50% max flow - Values in this table are typical values, not guaranteed values For information, to receive a quotes or to place...

Open the catalog to page 2

E-mail: sales@boreasa.com, URL : www.boreasa.com Electrical Connections Grey w/ red line Grey Grey Grey Grey Grey Hall sensor A Ground Internal Temperature Vhall 4.5 ... 24 VCC Hall sensor B Hall sensor C PLEASE NOTE PINOUT Motor winding 2 Motor winding 3 Motor winding 1 Blower Limits and Warning Manufacturing System Blowers manufactured by ISO9001-2015 certified manufacturer Motor Internal Temperature Signal (IT) The temperature of the inside of the motor is indicated by resistance of the NTC. The 100KΩ NTC (AVX p/n NB12P00104JBB) is connected between the Ground (PIN 2) and IT output (PIN...

Open the catalog to page 3

Small blower C60S1 3Pages

Catalog excerpts

All Boreasa Technologies Co. catalogs and technical brochures

Small blower C60S1
3Pages