Gas blower C75H1
3Pages

Catalog excerpts

E-mail: sales@boreasa.com, URL : www.boreasa.com Miniature Radial Blower: Housing and Impeller materials: Medical grade thermoplastics Lead Wire: 300mm (AWG22) Weight: 300 gr. (10.6 oz) Operational Temperature: -20 to 45 ºC / -4 to 113 ºF Three Phase Brushless Motor w/ Hall Sensor Connector # Molex Microfit 43025-1000 or 43025-0800 Motor Internal Temperature Signal 48V available upon request Note: This blower uses a brushless motor and needs a driver to operate Sample working point NOTES: - Performances are dependent on the driver used and the test conditions. The data in this spec. sheet was obtained using Boreasa test chamber at 20°C (±2° C) and sea level, and using a Boreasa D50/5/4Q-E2 driver. It may be different than data measured in other conditions or with other drivers. - When used as a vacuum, the blower performance might be less then shown herein, depending on the operating point. - Specifications are subject to change without notice. - Boreasa blowers have been designed and are manufactured to meet the medical device industry requirements. However, it is not possible to test blowers in all conceivable customer application configurations. Consequently, to be used in life support equipment, blowers must be life tested and validated by customers, in their actual application conditions, in a statistically meaningful quantity.

Open the catalog to page 1

E-mail: sales@boreasa.com, URL : www.boreasa.com IN work. point @Nom. Volt. PN work. point @Nom. Volt. n work. point @Nom. Volt. V work. point @Nom. Volt. P work. point @Nom. Volt. Depend on working point Leads Connector Molex Microfit 43025-1000 (10 wires) or 43025-0800 (8 wires) Housing / Impeller Material Medical grade thermoplastics Ball Bearing Motor Internal Temperature Sensor External cooling fan (for extreme applications) Mounting points available for 40mm fan For informa on, to receive a quotes or to place an order, e-mail us at sales@bor

Open the catalog to page 2

E-mail: sales@boreasa.com, URL : www.boreasa.com Electrical Connections Wire Blue Purple Yellow Orange White Grey Green Brown Red White Blower Limits and Warning Hall sensor A Hall sensor B Vhall 4.5 ... 24 VCC Motorwinding W Internal Temperature Hall sensor C Ground Motorwinding U Motorwinding V Internal Temperature Connector Pin 8 wires 10 wires (option) (standard) PIN 1 PIN 1 PIN 2 PIN 2 PIN 3 PIN 3 PIN 4 PIN 4 N/A PIN 5 PIN 5 PIN 6 PIN 6 PIN 7 PIN 7 PIN 8 PIN 8 PIN 9 N/A PIN 10 No Hot-Swap allowed Max. allowed temperature on Heat Sink: 75º C Max. cont. speed: 52’000 rpm Max. cont....

Open the catalog to page 3

Gas blower C75H1 3Pages

Catalog excerpts

All Boreasa Technologies Co. catalogs and technical brochures

Gas blower C75H1
3Pages