Catalogs >
Boreasa Technologies Co., Ltd >
Gas blower C65MS1-24PS-01-L5

Gas blower C65MS1-24PS-01-L5
3Pages

Catalog excerpts

E-mail: sales@boreasa.com, URL : www.boreasa.com Miniature Radial Blower: Housing and Impeller materials: Medical grade thermoplastics Lead Wire: 300mm (AWG22 & AWG26) Weight: 225 gr. (7.95oz) Operational Temperature: -20 to 50 ºC / -4 to 122 ºF Three Phase Brushless Motor w/ Hall Sensor Connector # Molex Microfit 43025-1000 Standard Motor Internal Temperature Signal Note: This blower uses a brushless motor and needs a driver to operate Sample working point NOTES: - Performances are dependent on the driver used and the test conditions. The data in this spec. sheet was obtained using Boreasa test chamber at 20°C (±2° C) and sea level, and using a Boreasa D30/5/4Q-E2 driver. It may be different than data measured in other conditions or with other drivers. - Specifications are subject to change without notice. - Boreasa blowers have been designed and are manufactured to meet the medical device industry requirements. However, it is not possible to test blowers in all conceivable customer application configurations. Consequently, to be used in life support equipment, blowers must be life tested and validated by customers, in their actual application conditions, in a statistically meaningful quantity.

Open the catalog to page 1

E-mail: sales@boreasa.com, URL : www.boreasa.com Technical Data C65MS1-24PS-01-L5 VCC Nominal Voltage IN work. point @Nom. Volt. PN work. point @Nom. Volt. n work. point @Nom. Volt. V work. point @Nom. Volt. P work. point @Nom. Volt. Depend on working point Leads Connector Molex Microfit 43025-1000 (10 wires) Housing / Impeller Material Medical grade thermo-plastics Ball Bearing Internal Temperature Sensor Note: - Working point is an example close to 50% max flow - Values in this spec sheet are typical values, not guaranteed values For informa on, to receive a quotes or to place an order,...

Open the catalog to page 2

E-mail: sales@boreasa.com, URL : www.boreasa.com Electrical Connections Blue Purple Yellow Orange White Grey Green Brown Red White Hall sensor A Hall sensor B Vhall 4.5 ... 24 VCC Motorwinding W Internal Temperature Hall sensor C Ground Motorwinding U Motorwinding V Internal Temperature Blower Limits and Warning Manufacturing System Blowers manufactured by ISO9001-2015 certified manufacturer Motor Internal Temperature Signal (IT) The temperature of the inside of the motor is indicated by the resistance of a NTC. The 10 KΩ NTC (EPCOS B57354V2103F060 or PANASONIC ERTJ1VG103FA), is connected...

Open the catalog to page 3

Gas blower C65MS1-24PS-01-L5 3Pages

Catalog excerpts

All Boreasa Technologies Co. catalogs and technical brochures

Gas blower C65MS1-24PS-01-L5
3Pages