BOA C150 Strip wound metal hose Application fields: The protective hose C150 is a strip wound metal hose with doublestrip profile, circular section, without gasket, limited tightness, therefore not recommended for conveying liquids and gases. Suitable for all-around movements, also in axial direction. No torsion is tolerated. Robust execution and resistant to vibration. Easy assembly. Material: stainless steel 1.4301 (similar to AISI 304) - as exhaust gas, ventilation and suction hose - for vibration and sound absorption in exhaust manifolds - applicable for small under-inflation, if a slight loss of air is tolerated - as inliner for pressure hoses operating very high flow rates, to prevent important pressure loss and too high sound emission. Temperature range: - 196°C up to max. 600°C Min. static bend radius [mm] Transverse pressure resistance min. [N] Preferred series, usually available at short term. Other  on request. Length measure The hose or hose assembly length shall be measured in either mid-position or in the extended position depending on the purchaser's requirements and shall be the length as ordered with a tolerance of ±3% unless otherwise stated (definition EN ISO 15465). The compressed measure length is 10–15% shorter, the installation length corresponds to the mid-position between extended and compressed position. To allow free movement in all directions, the installation length corresponds to the middle value between stretched and compressed measure. To connect fittings, an appropriate thin-walled tube is pulled over the hose end, then riveted to the hose profile, and brazed or welded. The three leaflets for metal hoses and metal hose assemblies "Technical Information“, „Installation Instructions“ and "Guarantee/ Delivery terms/ Conditions" are integrating part of the present product data sheet. Specifications subject to change without