BactoSenseTM Automated flow cytometer for online monitoring of water
4Pages

S afe W ater . Anytime. Anywhere . Automated flow cytometer for online monitoring of water Peace of mind - always know your water quality The best way to control the microbiological quality of your water is to analyse it. For more than a century, a laboratory was needed to detect bacterial contamination. Nowadays, the possibility to monitor on-site continuously opens up a new era of water quality monitoring. HPC (Heterotrophic Plate Count) Online FCM (Online Flow Cytometry) Since 1883 manually – within 3 days Since 1968 manually – within 3 hours Since 2017 automatically – within 20 minu

BactoSense – Fully automated water monitoring Your Challenges You need to monitor the quality of raw or ground water? You wish to improve your water treatment processes or ease your flushing procedures? You want to avoid bacterial contamination in your water distribution networks? In all cases you need an easy way to get quick results of your water analysis to take decisive actions. However, today’s methods are complicated, slow, not always accurate and can only be performed in a laboratory. Online sampling at any chosen point: at the inlet, before and after rapid and slow sand filtration,...

Innovation for your processes Safe and environmentally friendly handling The cartridge system of BactoSense removes the manipulation of toxic substances and avoids any contact with chemicals and their waste. The cartridge is hermetically sealed and reusable. It contains all you need for up to 1‘000 measurements, giving your instrument a full autonomy for 3 weeks to 9 months depending on the frequency of your analyses. The cartridge replacement is then easily done within short time. Easy to use BactoSense is a fully automated flow cytometer for the microbial analysis of water. It can be used...

BactoSense – Peace of mind does it work? Measurement type tailored by the cartridge All results can be retrieved from the database at any time to be evaluated. Depending on the cartridge used, specific sample parameters are shown on the dotplots. sample preparation detection LASER The process starts with staining of the sample, mixing, incubating (1 & 2) and measuring (3 & 4). The results are ready for exportation after only 20 minutes (5). The sample finishes its course into the integrated waste (6). The measuring cycle ends by a full cleaning of the instrument (7). Parameters available...